Hatco B-950P Installation Manual

Hatco / ADM Sneezeguards
Portable Sneeze Guards
Model B-950P
Model B-950P Portable Sneeze Guards are available in single bay
widths from 24"–66" (610–1676 mm). All of the available widths
are height adjustable from 13"–24" (330–610 mm) and have a
common base plate depth of 14" (356 mm).
For additional information regarding Model B-950P, scan the QR
Code below:
https://www.sneezeguard.com/info.php?
Model=B-950P-GLASS&pid=79&osCsid=q3ksj3df96tqad14o2vhcqrnu6
Important Safety Information
To avoid injury and damage to equipment or property, read the
following safety information before installing this equipment.
Do not attempt to assemble and install sneeze guards
alone. Installation of sneeze guards requires two or
more people, dependent upon unit.
Do not place anything on top of sneeze guard. It is not
designed to be a weight-bearing component.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit,
marring its appearance and making it susceptible to
soil accumulation. Use of abrasive materials will void
warranty.
Assembly and Installation
1. Unpack all components. Verify that the appropriate number of
the items below are present.:
• Glass Panel, 3/8"
• Post and Base Plate Assembly, Brushed Stainless Steel
• End Panel, 3/8" Glass x 2 (optional)
• Hardware Packet (includes hex wrench and extra set screws)
Glass
Clamp
Post and
Base Plate
Assembly
© 2022 Hatco Corporation
2. Verify the mounting position of the posts on each base plate.
The posts are pre-installed on each base plate in the center
position. They can be moved to the offset position, if necessary:
a. Use the included hex wrench to loosen the set screw
b. Using a 7/16" socket wrench, remove the nut on the bolt
Legs in center position.
3. Open up the stabilizer tabs on the base plates.
• The base plate of each post assembly has retractable
stabilizer tabs that can be pivoted out for extra stability during
installation or operation.
Tabs in retracted postion.
Glass Panel
4. Prepare to install the glass panel.
• There are two mounting holes provided on each side of the
glass panel. Choose the hole position that will work for the
installation. Install the provided filler cap assembly in the
unused holes using a coin to hand-tighten.
Height
Adjustment
Twist-Lock Nut
Filler Cap
Underside
of glass
Filler Cap
1
P/N 07.14.007.00-1222 [B950P_IG]
INSTALLATION GUIDE
securing the post to the base plate flange. Remove the base
plate from the post.
inside the base plate flange that secures the flange to the
base plate. Then, reinstall the posts in the offset position
of the base plate. Use a torque wrench to tighten the nut to
20 ft-lbs.
Base Plate
Flange
Use coin
here.
Cover
panel.
Cover
Post
Legs in offset position.
Tabs pivoted to open postion.
Filler Cap
Assembly
installed.
Top side
of glass
panel.