Contents 1. Overview (01-03) Packing List (01) Baby Unit (02) Parent Unit (03) 2. Getting Started (04) 3. Camera Placement ( on the wall ) (05) 4. Function Operation (06-07) 5. Switching Cameras (08) 6. Replacing the Camera Len (09) 7.
1. Overview 1.1 Packing List Parent Unit x 1 Baby Unit (Camera) x 1 USB C Cable x 2 USB Chargerx 2 Set Screw x2 Wide-Angle Len x 1 7800mAh Extra-Long Battery Life U S E R M A N U A L Positioning Card User Manual x 1...
1.3 Parent Unit 09 10 Display Zoom Play Music Power Button Up Arrow Key Intercom Volume Left Arrow Key Microphone OK Button Antenna Volume Level Indicator Power Indicator Right Arrow Key Speaker Menu/Back/Camera/Video Recording Down Arrow Key USB-C Charging Port Reset Hole...
2. Getting Started Step 1. Step 2. Connect the AC power Press for two seconds to adapter with camera. turn on the parent unit. Plug the AC power adapter into power socket. Notes:The two units has already been paired in factory settings, so no repeated operation is needed in most cases. But if the auto pairing failed or you want to add more cameras, please try step 3 and step 4.
3. Camera Placement ( on the wall ) Step 1. Step 2. Put the camera at the pre-installation angle, Push the matching anchors into the holes. then viewing from the display monitor, Screw on with a screwdriver, leaving 1cm of check if the angle is OK the screw outside of the hole Using positioning card included, punch two holes...
5. Switching Camera 5.1 Switch cameras manually 5.2 Turn on multiple cameras scan mode When two or more cameras are connected,Press the "OK" button to enter the split screen mode. You can now use the arrow keys to select a screen you want to zoom in, and press the "OK"...
6. Replacing the Camera Len Rotate to remove the decorative ring of ve ring of Take out the additional wide-angle lens, Take out the ad the original lens (please keep the removed he removed align it and screw it in, pay attention to align it and scre decorative ring properly, it needs to be ds to be...
7. Maintenance and Warranty Maintenance All of the following maintenance procedures should only be performed when baby and parent units are unplugged and turned off. Clean the surfaces of the baby and parent units with a soft, fluff-free cloth. Never use cleaning agents or solvents. If the units become dirty, use a slightly damp cloth to wipe surfaces.
10. Troubleshooting No signal on the Parent Unit The power adapters may not be properly connected. Confirm the toggle switch of the Baby Unit is in "Power On" position Confirm the Parent Unit has power and is powered on Ensure the Baby Unit and Parent Unit are not far from each other. The baby Unit and Parent Unit may not be properly paired.
Page 16
FCC WARNING: This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.