Ariens Sno-Thro ST926LE Owner's/Operator's Manual page 21

GENERAL LUBRICATION
IMPORTANT: Wipe each fitting clean before
and after lubrication. Do not wipe gearcase
filler plug; wiping the gearcase filler plug may
Grease
Oil
remove thread sealant and cause leaks.
IMPORTANT: DO NOT allow grease or oil to
get on friction disc, friction plate or belts.
NOTE: Apply Ariens Hi-Temp Grease or
equivalent to the lubrication fittings. See
SERVICE PARTS on page 32.
Sno-Thro should be lubricated (Figure 18) at
beginning of season or every 25 operating
hours.
Auger Shaft
OS7135
NOTE: To grease auger shaft, remove shear
bolt nuts, and shear bolts. Apply grease at the
OS0642
grease zerks and then turn the auger shaft.
Replace shear bolts per instructions in Shear
Bolts on page 22.
OS7145
Figure 18
GB - 21