Table of Contents
Advertisement
Available languages
Available languages
PR114FR
•
Remove all packing material, both inside and outside.
•
Clean the outside of the unit with a dry cloth. You can clean the inside with a
soft damp cloth.
•
Do not place the appliance in a narrow passage, direct sunlight or moisture.
•
Make sure that air can circulate freely around the refrigerator. The back of the
refrigerator should be at least 13 cm away from the wall.
•
Place the refrigerator on a firm, level surface.
•
Avoid direct sunlight and heat. Sunlight can damage the outside of the
refrigerator. Heat will cause higher consumption.
•
Avoid excessive humidity. Too much moisture in the air will cause frost to form
too quickly in your refrigerator.
•
You can set the temperature at the back of the appliance with the thermostat.
The higher the setting (5), the harder the refrigerator will cool.
You can change the direction of rotation of the door. If you wish to do so, proceed
as follows:
Attention : Make sure that the appliance is not live!
1.
Remove the protective cap from the hinge and the cover plate on the other
side. In the door, remove the cover cap at the top.
2.
Remove the 3 screws located in the upper hinge. Remove the upper hinge.
Then you can lift the door out of the lower hinge. Put them in a place where
you can store them scratch-free. When you change the direction of rotation
of the door, we recommend that you rotate the rubber seal as shown in the
picture. This will allow the door to seal perfectly when you replace it.
INSTALLATION
DOOR CONVERSION
36
WWW.PRIMO-ELEKTRO.BE
Advertisement
Table of Contents
