Installation Information - Peavey IPA 150 TII User Manual

WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN
DISCONNECTED FROM ITS POWER SOURCE.
LINE CORD (120 V PRODUCTS ONLY) (13)
For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities. It
is not advisable to remove the ground pin under any circumstances. If it is necessary to use the equip-
ment without proper grounding facilities, suitable grounding adaptors should be used. Less noise and
greatly reduced shock hazard exist when the unit is operated with the proper grounded receptacles.

INSTALLATION INFORMATION

INSTALLING THE RACK-MOUNT EARS
This unit can be rack-mounted with an optional rack-mount kit. To attach the rack-mount ears, simply
remove the three screws already in the front on either side of the unit and align the ears with the rack-
mount flange forward of the unit. Replace the screws and tighten securely, being careful not to over-
tighten. The unit then mounts in a standard two-space 19" rack. You may find it desirable to remove the
rubber feet from the bottom of the unit in rack-mount installations. The rack-mount ears may also be
used to secure the unit in a shelf application to deter theft.
RACK-MOUNT RECOMMENDATION
To provide adequate ventilation, leave at least one rack space between units when multiple amplifiers
are mounted in the same rack.
IPA 75T II ARCHITECTURAL AND ENGINEERING SPECIFICATIONS
The power amplifier input shall have screw terminal connections and a sensitivity switch. The unit shall
have LED indicators to show Power, Activity, and SPS™ compression. The unit shall have a front panel
level control, as well as a defeatable subsonic filter.
The unit shall be packaged in a rugged metal chassis 17" wide by 3 1/2" high by 15 5/8" deep. The unit
shall operate from standard 120 volts AC, 60 Hz power. The internal power amplifier shall be capable of
delivering 75 watts into 4 ohms and 8 ohms, as well as providing 25 volt and 70 volt balanced line
outputs. The unit shall be capable of delivering rated power from 20 Hz to 20 kHz 0.5 dB into 4 ohms
at its direct output at 0.5% or less distortion with hum and noise at least 95 dB below rated output. The
unit shall be called the Peavey Architectural Acoustics Division model IPA™ 75T II.
IPA 150T II ARCHITECTURAL AND ENGINEERING SPECIFICATIONS
The power amplifier input shall have screw terminal connections and a sensitivity switch. The unit shall
have LED indicators to show Power, Activity, and SPS™ compression. The unit shall have a front panel
level control, as well as a defeatable subsonic filter.
The unit shall be packaged in a rugged metal chassis 17" wide by 3 1/2" high by 15 5/8" deep. The unit
shall operate from standard 120 volts AC, 60 Hz power. The internal power amplifier shall be capable of
delivering 150 watts into 4 ohms and 8 ohms, as well as providing 25 volt and 70 volt balanced line
outputs. The unit shall be capable of delivering rated power from 20 Hz to 20 kHz 0.5 dB into 4 ohms
at its direct output at 0.5% or less distortion with hum and noise at least 95 dB below rated output. The
unit shall be called the Peavey Architectural Acoustics Division model IPA™ 150T II.
5