Mitsubishi Electric MSZ-AY25VGKP Operating Instructions Manual page 17

W
i-Fi INTERFACE SETTING UP
®
NET LED
NET LED fl ashing indicates that the Wi-Fi
router.
When it doesnʼt connect well
Check the following, and pair the Wi-Fi
Selecting a mode.
• Make sure that the communication distance is not too far between the Wi-Fi
interface and the Router.
• Make sure that the Router uses WPA2-AES encryption.
• Make sure that the number of connected devices to the Router does not exceed
the limit.
• Make sure that DHCP is enabled, or check IP address setting of the Wi-Fi
interface.
• Check DNS settings of the Router, or check DNS address of the Wi-Fi
face.
• Check if the Router is connected to Internet.
• Set up the Wi-Fi interface after operating the air conditioner using the wireless
®
remote controller at least once.
If the connection fails even after checking the above, set up the Wi-Fi
and the router again by the following method.
• Hold down the Temperature for 5 seconds.
• Select "_ 2" by pressing Temperature
• Point the remote controller toward the indoor unit and press the
• The indoor unit beeps 3 times when resetting is complete.
[About trademarks]
• WPS is the connection via Wi-Fi Protected Setup™.
• "Wi-Fi ", "Wi-Fi Protected Setup™", "WPA2™" are trademarks or registered
®
trademarks of the Wi-Fi Alliance .
®
The Wi-Fi interface uses Open Source Software. To view the Open Source
®
software licence(s), please go to the following website whilst connected to
the Wi-Fi interface during the Access Point mode.
®
http://192.168.11.1/license
interface is communicating with the
®
interface and the Router according to
®
inter-
®
interface
®
and .
.
Note:
• Ensure that the Router supports the WPA2-AES encryption setting before
starting the Wi-Fi interface setup.
®
• The End user should read and accept the terms and conditions of the Wi-Fi
service before using this Wi-Fi
• To complete connection of this Wi-Fi
Router may be required.
• This Wi-Fi interface will not commence transmission of any operational data
®
from the system until the End user registers and accepts the terms and con-
ditions of the Wi-Fi service.
®
• This Wi-Fi interface should not be installed and connected to any Mitsubishi
®
Electric system which is to provide application critical cooling or heating.
• Please write down the information regarding the Wi-Fi
the last page of this manual, when you set up this Wi-Fi
®
• At the time of relocation or disposal, reset the Wi-Fi
default.
Mitsubishi Electric's Wi-Fi
®
Mitsubishi Electric's MELCloud Wi-Fi
®
Mitsubishi Electric is not responsible for any (i) underperformance of a
system or any product;
(ii) system or product fault; or (iii) loss or damage to any system or product;
which is caused by or arises from connection to and/or use of any third
party Wi-Fi interface or any third party Wi-Fi
®
Electric equipment.
For the latest information regarding MELCloud from Mitsubishi Electric
Corporation, please visit www.melcloud.com.
interface.
®
interface to the Wi-Fi
® ®
interface setting on
®
® interface.
interface to the factory
®
interface is designed for communication to
service.
®
service with Mitsubishi
®
®
service, the
EN
EN-16