senva TotalSense Series Installation Instructions Manual

INSTALLATION INSTRUCTIONS
TM
T talSense
Indoor Air Quality Sensor
BACnet/Modbus/Analog
IMPORTANT WARNINGS
• Only qualified trade installers should install this product
• This product is not intended for life-safety applications
• Do not install in hazardous or classified locations
• The installer is responsible for all applicable codes
• De-energize power supply prior to installation or service
PRODUCT APPLICATION LIMITATION:
Senva products are not designed for life or safety applications. Senva products
are not intended for use in critical applications such as nuclear facilities, human
implantable device or life support. Senva is not liable, in whole or in part, for
any claims or damages arising from such uses.
FEATURES
The TotalSense series design allows customization for a sensor
that meets project requirements for monitoring temperature,
carbon dioxide (CO2), total volatile organic compounds
(TVOC), particulate matter (PM), relative humidity (RH),
passive-infrared occupancy sensor (PIR), and ambient light.
The product can be ordered as a stand-alone CO2, RH, Temp,
TVOC, PM, or PIR sensor as well as almost any combination of
sensors. Resistive-set-point sliders and pushbuttons are also
available to meet the requirements for any job. All models
come standard with programmable set-point relay (except on
PM models) and barometric pressure compensation for CO2.
Choose the analog version to receive up to three
selectable and programmable analog outputs or utilize the
communications version to access a myriad of data through
Modbus RTU or BACnet MS/TP. Communications version
comes standard with ambient light sensing.
To verify the features see the
'Product Identification' section of
the installation manual or use the
configuration tool at senvainc.com or
scan the QR code on the right.
senvainc.com 1-866-660-8864 (F)1-503-296-2529 9290 SW Nimbus Ave. Beaverton Oregon 97008
Series
TotalSense Configurator
PRODUCT IDENTIFICATION
Pkg Out CO2 RH
AQ2 -
Package
W = Surface
Output Type
A = 3-wire Analog
B = BACnet/Modbus
CO2
A = None
C = Standard CO2
D = Dual Channel CO2
Relative Humidity
A = None
2 = 2% RH accuracy
VOC
A = None
V = TVOC
Particulate Matter
A = None
P = PM 1.0, 2.5, 4.0, 10.0 (Available on AQ2W-B
BACnet/Modbus versions only)
Temperature Output
A = None
B = Transmitter and display/comms temp reading
C = 100Pt RTD
D = 1000Pt RTD
E = 10K Type 2
F = 10K Type 3
G = 10k w/11k
H = 3k
I = 2k2
J = 1k8
K = 20k
Display
X = None
D = Color OLED Display
S = Color OLED display with solid cover
R = Air Quality Ring
PIR Motion/Occupancy Sensor
Blank = None
P = PIR Sensing
Accessories † ‡
C = 1k Ω Setpoint Slider
D = 10k Ω Setpoint Slider
T = 200-900 Ω Setpoint Slider
E = 910 Ω offset resistor (available with slider only)
S= Slider override Pushbutton (available with slider only)
O = Thermistor Override Pushbutton
U = User Pushbutton
Additional Setpoint sliders and offset resistors available
†
upon request
‡ Slider and pushbutton options not available with PM sensor
Disp
VOC PM T Acc