Advertisement
(Step 6)
Peavey Electronics Corporation • 711 A Street • Meridian • MS • 39301
©1999
Extension Arm Assembly
Scale .250
(Step 10)
(Step 11)
(Step 7)
(Step 8)
Features and specifications subject to change without notice.
(601) 483-5365 • FAX (601) 486-1278 • www.peavey.com
Step 10.
Position the CH-7 horn bracket up against the
CH-7 horn throat with the bottom of the metal
flange facing toward the rear base edge. Two
holes in the metal bracket and in the base should
be in reasonable alignment. Install the 44XT
driver to the horn throat with four 1/4" x 3/4"
machine screws and flatwashers.
Step 11.
Position the CH-7/44XT and bracket assembly
onto the top of the midrange horn. The horns
should align at the front edge. Install two 1/4" x
1 1/4" machine screws and flatwashers through
the 44XT bracket, wood base, and into two t-nut
holes provided in the midrange horn top. Do not
overtighten.
S t e p 1 2 .
Tilt and pivot the midrange horn assembly as
required by the room area coverage and tighten
all pivot and extension arm hardware.
80304619
Printed in the U.S.A. 6/99
™
Advertisement
