Table of Contents
Advertisement
Quick Links
KX7S Touchscreen
PRODUCT SAFETY
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT.
Do not let power supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Do not use the unit near water.
Do not allow objects to fall or liquids to be spilled
into the enclosure through openings.
Equipment should be mounted in locations and at
heights where it will not readily be subjected to
tampering by unauthorized personnel.
SAVE THESE INSTRUCTIONS.
GETTING STARTED
Overview
The Encelium KX7S Touchscreen is a 177 mm (7 inches) flush-mount LCD touchscreen display that provides the ability to
recall multiple lighting scenes for a given zone. It's ideal for large multi-purpose spaces where lighting requirements vary
throughout the day, such as an auditorium or conference room.
The use of accessory equipment is not recommended
by Encelium as it may cause an unsafe condition.
Do not use this equipment for other than the
intended use.
Advertisement
Table of Contents
Related Manuals for Encelium KX7S
Summary of Contents for Encelium KX7S
- Page 1 GETTING STARTED Overview The Encelium KX7S Touchscreen is a 177 mm (7 inches) flush-mount LCD touchscreen display that provides the ability to recall multiple lighting scenes for a given zone. It's ideal for large multi-purpose spaces where lighting requirements vary...
- Page 2 KX7S Touchscreen INSTALLATION INSTRUCTIONS SYSTEM OVERVIEW Wired System Overview With Encelium X, you can control DALI devices exclusively or a mixture of GreenBus and DALI. GreenBus DALI KX7S Touchscreen Installation Instructions...
- Page 3 KX7S Touchscreen INSTALLATION INSTRUCTIONS Wireless System Overview This illustration shows how each component is easily integrated into the Encelium X Lighting Control System. KX7S Touchscreen Installation Instructions...
- Page 4 Note: There is little margin for error when fitting the KX7S Touchscreen into the wall opening. Make sure to use the included cardboard cut-out template to create the correct size opening in the wall. Additionally, carefully double-check that all measurements taken using the cardboard cut-out template are accurate.
- Page 5 XP-6S Advanced Control Processor The XP-6S Advanced Control Processor can be either rack-mounted (mounting bracket included) or free standing in the IT closet. INSTALLATION KX7S Touchscreen The KX7S Touchscreen is rated for dry, indoor locations only. RS-232 CONTROL ETHERNET Front View...
- Page 6 USB Port Two mounting wings are located on the top and bottom of the KX7S Touchscreen, which can be used to secure the KX7S Touchscreen to drywall in retrofit installations. Place KX7S Touchscreen in the opening in the wall and tighten the mounting wing screws located on the front of the KX7S Touchscreen (bezel removed).
- Page 7 Rear View To access the XP-6S front panel, pull the cover forward to remove. A single XP-6S Advanced Control Processor can be used to control up to 100 KX7S Touchscreens in a single site. The KX7S is powered via PoE.
- Page 8 Note: A PoE network switch is required to power the KX7S TROUBLESHOOTING There are no user-serviceable parts inside. For detailed information about how to set-up, install, use, and maintain Encelium hardware and software, please visit: help.encelium.com Copyright ©...
Need help?
Do you have a question about the KX7S and is the answer not in the manual?
Questions and answers