Table of Contents
Advertisement
11
11
11
11
11
Setting up the Rocket
The Rocket Jig consists of 3 main components; the upright (A), base plate (B)
and Rocket riser block (C). Two (2) 3/4" screws and two (2) 2-1/2" screws are
included to assemble the 3 components in different configurations for drilling.
(A)
TM
Rocket
The Rocket
Face Clamp
it to the workpiece while drilling the pocket holes. The Face Clamp
can then be removed and used to assemble the joint as shown below. In
addition the Rocket
temporarily attach the tool to any workpiece in any location by simply
driving a screw. A nice feature in situations where pocket holes could
normally not be used because of a clamping obstacle.
1
Fence (1) slides up and down
to capture Face Clamp
Clamp also serves to hold
workpieces flush while driving
screw (3).
(B)
Sliding Base Plate
TM
Jig utilizes a sliding base plate which allows the Kreg
TM
to slide into the recess on the back of the jig and secure
TM
Jig features a mounting hole that allows you to
A
(2).
TM
TM
Jig
(C)
2
3
TM
Hide quick links:
Advertisement
Table of Contents
