Table of Contents
Advertisement
2. HARDWARE SETUP
13) CPU and Power Supply Fan Connectors (3-pin CPU_FAN, PS_FAN)
Orientate the fan so that the heat sink fins allow airflow to go across the onboard
heat sink(s) instead of the expansion slots. Depending on the fan manufacturer,
the wiring and plug may be different. The red wire should be positive, while the
black should be ground. Connect the fan's plug to the board taking into consid-
eration the polarity of the connector.
NOTE: The "Rotation" signal cannot be monitored on this motherboard.
WARNING!
The CPU and/or motherboard will overheat if there is no airflow
across the CPU and onboard heatsinks. Damage may occur to the motherboard
and/or the CPU fan if these pins are incorrectly used. These are not jumpers,
do not place jumper caps over these pins.
CUW-AM
CUW-AM 12-Volt Cooling Fan Power
14) LCD-TV Headers (Two 20-1 pin LCDTV)
These headers require an optional LCD module for LCD output or a TV-out
module for TV output.
CUW-AM
CUW-AM LCD-TV Headers
16
0 1
0 1
CUW-AM User's Manual
PS_FAN
GND
SYS_FAN
+12V
CPU_FAN
Rotation
LCDTV
1
Advertisement
Table of Contents
