VALBERG GGH 5 IC 066T Instructions For Use Manual page 14

C
Useful information
CAUTION:
Be sure to follow the instructions below before replacing
the components:
• Check that the burner crown holes are not blocked.
• Check that the
(fig. ) are correctly positioned onto the burner crowns. The
6
burner caps must be stable.
• The exact position of the support grate is determined by
its rounded corners, which must be oriented towards the
side edge of the hob.
• Do not force the valves if they are difficult to open or close.
Contact technical support for repairs.
• After use, be sure to protect the hob surface by applying
appropriate cleaning products, which are easily available in
outlets. This keeps the surface of the hob plate clean and
also prevents rust from forming.
• Never use a steam cleaner to clean the appliance.
22
cast-iron burner caps
EN
C
Useful information
Always disconnect the appliance from the power supply
and turn off the gas supply before carrying out any repairs.
Replacing hob components
Replacing the unit's internal components: Remove the
support grates and burners from the upper part of the hob;
C
remove the burner fixing screws
(fig. ) and the control knobs by applying hand pressure to
V 14
remove them from the appliance.
Once this has been done, the burners (fig.
) and electrical components can be replaced (fig.
replacing a valve, it is also advisable to replace the
the same time to ensure an optimal seal.
Remove the screws and control knobs (letter
connect the burners to the hob. After removing the lower
screws, replace the electrical components as necessary.
If the appliance is fitted with an automatic ignition system
and an automatic locking system, remove the microswitches
before removing the gas valves.
To ensure optimal sealing, we recommend replacing the
joints when replacing the valves.
), valves (fig.
15
). When
17
D
V
23 EN
16
seal at
), that