Sensio Richmond Installation Instructions

INSTALLATION

INSTRUCTIONS
IMPORTANT: Please read these instruc�ons before commencing installa�on and retain for future reference.
Bathroom Ligh�ng Zones:
0
Inside the bath or shower.
Must be SELV (12V Max) due to
water submersion.
Minimum ra�ng of IP67.
1
225cm above the bath or shower.
Minimum ra�ng of IP44.
2
The area stretching to 60cm outside
the bath or shower, and 60cm from
the water outlet of the sink. An IP
ra�ng of at least IP44 is required.
This mirror is IP44 rated and
suitable for installa�on in zone
2 and the outside zones.

Components

Illuminated LED Mirror 4 x Rawl
Plugs

Tools Required

Pencil Screwdriver Ø8mm
Drill Bit
Waste Electrical & Electronic Equipment (WEEE)
The symbol on the product, or on the document accompanying the product, the crossed out wheelie bin symbol, indicates
that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collec�on point for the recycling of electrical and electronic waste.
PRBA00010 V1
V3
Illuminated LED
Mirror IP44
Outside Zones - Anywhere outside zones 0, 1 and 2, where water jets are not used for cleaning purposes, the general rules
of BS7671 apply.
Important Safety Informa�on
Please read these instruc�ons carefully before a�emp�ng to install this product. It is advisable to keep
these instruc�ons in a safe place for future reference.
We recommend that you consult a qualified electrician. All electrical installa�on must be carried out in
accordance with the current IEE wiring regula�ons (BS7671) and the latest relevant building
regula�ons.
This product must not be modified, if any modifica�ons are made, it may invalidate the warranty and
may render the product unsafe. These LED lights operate low voltage (24V).
This p This product is for indoor use only.
4 x 1 x Instruc�ons
Screws Manual
Safety Instruc�ons
1. If in doubt, installa�on must be carried out by
2. Before commencing installa�on or
3. This product is only suitable for connec�ng to
4. The mirror should be mounted onto a secure
Power Drill
a qualified electrician.
maintenance, isolate the main electrical supply
for the appropriate circuit at the fuse board.
a 240V 50Hz supply. a 240V 50Hz suppl
surface.
5. When installing, please take care to avoid
water pipes, joints and electrical cables.
6. This product has a ra�ng of IP44.
7. Do not exceed or stretch cables.