Panasonic WJ-HDE300 Instructions Manual page 12

Device Case & Step
A B
1 1
2 2
3
3
12
C D
• For Case 1, turn on the power switches of the extension units .
→ The unit will be restarted.
1 1
• For Case 2, jump to step 2.
• Press the RESET button.
Initializing Procedures
1. Set the MODE switch to SINGLE.
2. Hold down the RECOVER button. (Do not release it
yet.)
3. Press the RESET button while holding down the
2
RECOVER button.
→ The HDD POWER indicator will go off.
4. Release the RESET button first.
(Do not release the RECOVER button yet.)
5. Confirm that the HDD POWER indicator turns on,
then release the RECOVER button. It may take
around 5 seconds until the indicator turns on.
6. Set the MODE switch back to RAID5.
Data Recovery Procedures
1. Confirm that the MODE switch is set to RAID5.
2. Hold down the RECOVER button. (Do not release it
yet.)
3. Press the RESET button while holding down the
RECOVER button.
2
→ The HDD POWER indicator will go off.
4. Release the RESET button first. (Do not release the
RECOVER button yet.)
5. Confirm that the HDD POWER indicator turns on,
then release the RECOVER button.
→ Data recovery will start automatically.
6. Repeat the above steps until all the extension units
start data recovery.
* It will take around 12 hours to complete data recovery if the HDD size is 160 GB.
* It is possible to start operation of the digital disk recorder even while the extension unit
is recovering data although it may take a longer time to complete the data recovery.
Important
Do not touch any button or switch during data recovery. Otherwise, data recovery will be
canceled and will be incomplete. During data recovery, the HDD access indicator alter-
nately blinks orange and red or steady orange. When data recovery is complete it turns
off or blinks green.
• When the POWER switch is off, turn it on after completing the installation.
• When HDD SAFETY MODE is set to ON in the menu setup, set it to OFF
and press the SET button.
→ The digital disk recorder will start up.
In the case of A, B, or C, "HDD DISK MENU" will be displayed auto-
matically. Then, format and configure the target hard disk.
3 3
In the case of D, the "REMOVE" status will be displayed on the task bar
of the WJ-HD316/309. To cancel it, manually open "HDD DISK MENU"
once, and click the "EXIT" button.
Refer to the operating instructions of the digital disk recorder for details.
Start-up Procedures
POWER
RESET
SINGLE RAID5
ERROR
RESET
HDD
MODE
POWER
SINGLE RAID5
HDD 3
POWER
HDD POWER
Press Release
OFF ON
OPERATE RECOVER
2
5
HDD
Press Release
POWER
O
SINGLE RAID5
SINGLE RAID5
HDD
POWER
ERROR
RESET
MODE
SINGLE RAID5
HDD 3
POWER
HDD POWER
Press Release
OFF ON
OPERATE RECOVER
HDD
POWER
2
5
Press Release
SET
4
4
POWER