Panasonic WJ-HDE300 Instructions Manual page 11

7.
Place the brackets with the fixed HDDs into the unit and
fix them using the four screws removed in step 3.
• Do not use an electric screwdriver to fix them.
Recommended tightening
{8 kgf · cm}
8.
Connect the cables.
9.
Attach the metal plate removed in step 2 with the six
screws (marked with ∆) previously removed.
10.
Connect the detached harness as it was.
torque = 0.784 N · m
11.
Attach the front cover as it was.
11-1 Align both the left edges of the front cover and the
unit, and then push the front cover onto the unit.
11-2 Slide the front cover to the right.
Note: The front cover may be attached and detached
as necessary in the next step 12. Be careful not to
damage the harness.
12.
Turn on the power of the system to reconstruct the sys-
tem.
See the table on the next page to perform start-up pro-
cedures. Note that step 1 in the next page depends on
how you have cut the motor power in case 1 or 2 men-
tioned in page 9.
Take the steps in order depending on the cases A, B,
C, and D.
Case A: Extension units not configured yet and newly
installed or added to be run in SINGLE or RAID5
mode.
Case B: Extension units already configured in SINGLE
mode and having HDD added, removed, or
replaced.
Case C: Extension units already configured in RAID5
mode having HDD added or removed.
Case D: Extension units already configured in RAID5
mode having replaced HDD.
Important: Turn the units on in the following order.
The extension units need to be turned on first and
the digital disk recorder is the last.
Note: The digital disk recorder will need about three to
five minutes to complete the system check that is
started as it is turned on. The time length depends
on the connections and number of the extension
units.
11