Frigidaire FGAC5045W1 Use & Care Manual page 14

14
OPERATING INSTRUCTIONS
Situation
When bucket full or clean filter light is
on.
When E4, EC, AS or ES error occur.
When unit is connecting to internet.
• When the unit is establishing connection to
internet the quick glance light will flash in
white light and
established the quick glance light will emit
white light for 10 sec then follow the
behavior in above table.
• The light can be activated or deactivated by
pressing and holding the "Fan Speed"
button and "+" button simultaneously for 3
sec.
NOTE
Unit must be upright for one hour prior to
operating.
1. Plug the power cord into a properly
grounded 115 volt AC outlet.
NOTE
If the "BUCKET FULL" light is flashing,
remove the bucket and re-install to reset the
float switch.
if the connection
Quick Glance Light Behavior
The light will emit orange light and gradually
turn dark and bright every 4 sec.
The light will emit red light and gradually turn
dark and bright every 4 sec.
The light will flash white light.
2. To turn the unit on, press the ON/OFF
button. The unit will run in the factory
is setting of Auto mode. In this mode, the unit
will automatically
humidity and fan speed according to the
indoor environment.
Note: In this mode, set humidity and fan
speed can not be changed manually and the
display will show actual room humidity.
3. To use Quiet mode, press the Mode button
to choos Quiet mode. The unit will run in
low fan speed for the whole time and the
unit will automatically set a comfortable
humidity
environment.
Note: In this mode, set humidity and fan
speed can not be change manually and the
display will show actual room humidity.
set a
according to the
comfortable
indoor