Table of Contents
Advertisement
Airstryke II Aerobar
INTRODUCTION
Thank you for purchasing this set of Profile Design Aerobars. These instructions apply to the Airstryke II Aerobar.
Please read these instructions thoroughly before attempting to install this item. Proper installation is required for compliance with Profile Design's
warranty policy. If you are not familiar with installation of Aerobars or their accessories, please seek the assistance of your local Profile design dealer
by logging on to www.profile-design.com and using "dealer search" or by calling Profile Design's customer service number p.# 888.800.5999.
Note to Dealers: If you install this product for the consumer, please provide him/her with this owner's manual after installation.
Tools and materials required:
• 5mm Hex Wrench
• Torque Wrench with a 5mm Hex fitting
• Assembly compound
• Lithium grease
• Isopropyl alcohol
• Cutting guide and hacksaw (18T blade)
• Half round file
• Electrical/Insulation tape
• Clean, lint free cloth
1
Advertisement
Table of Contents
