Fcc Caution; Charging Battery Pack - Bosch BC1880 Instructions Manual

The manufacturer is not responsible for radio
interference caused by unauthorized modifications
to this equipment. Such modifications could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE! This equipment has been tested and found to
comply with the limits for a Class B digital devices,
pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
Plug charger cord into your standard power outlet.
With no battery pack inserted, the charger's green
indicator light will go ON. This indicates the charger is
receiving power and the charger is ready for operation.
When you insert the battery pack into the
charger. The charger's green indicator
light will begin to "BLINK". This indicates
that the battery is receiving a fast charge.
Once approximately 80% battery capacity has been
reached, the blinking of green light will slow down,
indicating that fast charging is now complete. If battery
remains in charger, the charging process is completed in
Long Life charging mode.
The purpose of the rapidly "BLINKING" green light is to
indicate that the battery pack is fast-charging. It does not
indicate the exact point of full charge. The light will stop
blinking when battery is fully charged.
Continuous green battery charger light
indicates that the battery is fully charged.
However, the battery pack may be used at
any time, even if the green light is still blinking.
A steady red indicator light means that
the battery pack is outside the proper
temperature ranges (too hot or too cold)
so the charger will not begin the charging
process. Charging (Fast or long Life Charging Mode) is
only possible when the temperature range of the battery
pack is between 32°F (0°C) and 113°F (45°C). When
needed, the internal fan of the charger will turn on to aid
the charging process and speed.

FCC Caution:

particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.

Charging Battery Pack

If the red indicator light is "BLINKING", the battery pack
cannot accept a charge. This may be due to the contacts
on the charger or battery pack is contaminated, the
battery pack itself may be defective, or battery may be
wrong type for this charger.
•
charger by checking charger Warning label.
•
battery pack into charger to verify charger is working
properly.
• Clean the contacts of the charger or battery pack (e. g.
by using a cotton swab and alcohol on battery and charger
terminals or inserting and removing the battery several
times) or replace the battery pack, as required.
When the battery pack is fully charged, unplug the charger
(unless you're charging another battery pack) and slip the
battery pack back into the tool.
4-
-
As soon as the battery pack reaches the
correct temperature range, the battery
charger will automatically switch to fast
charging.
Check to see if the battery is compatible with
If applicable, insert another compatible