Wall Mounting - Panasonic KX-THA13 Operating Instructions Manual

Wall mounting

The cordless camera can be mounted by the following way:
– Standard mounting
– Upside down mounting
CAUTION:
L For information of the cordless camera location, see page 9.
L Confirm the detection range of the cordless camera before installing the cordless
camera on the wall (page 9).
L Confirm the MAC address on the bottom of the cordless camera before installing the
wall mounting adaptor. This MAC address is needed when you use the MULTI TALK V
Camera Utility software.
L Mount the cordless camera on the stable location where the unit can be adequately
supported when installing.
L The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet.
Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the
adaptor may cause it to become disconnected.
L Do not mount the cordless camera on a soft material. It may fall down, break or
cause injury.
L Do not mount the cordless camera on the following places: plaster board, ALC
(autoclaved lightweight cellular concrete), concrete block, plywood less than 25 mm (1
inch) thick, and etc.
L Do not pull the call button wire after you mount the cordless camera on the wall.
L After mounting the cordless camera on the wall, speak loudly and clearly into the MIC
when talking with the handset user.
Connecting the wall mounting adaptor
A Slide the cordless camera into the wall mounting adaptor in the direction of the arrow
until it clicks into the place.
B Tuck the call button wire into the hole on the side of the wall mounting adaptor.
C Fasten the call button wire to the hook of the wall mounting adaptor.
A
For assistance, please visit http://www.panasonic.com/phonehelp
Useful Information
B
C
39