Installation And Wiring - Unitronics UMI-S0 Series Technical Specifications And Installation Manuallines

Inverter power filters Technical Specifications, Installation Guide

Installation and Wiring


Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration, in
accordance with the standards given in the product's technical specification sheet.

Do not place in water or let water leak onto the unit.
 Ventilation: 10mm space required between controller's top/bottom edges & enclosure walls.

Do not touch live wires.

All wiring activities should be performed while power is OFF.

Use over-current protection, such as a fuse or circuit breaker, to avoid excessive currents
into the unit.

Use wires that are properly sized for the load.

Double-check all wiring before turning on the power to the system.

The filter is recommended to be used in TNC system.

The input filter cannot be used as an output filter, and vice versa.

Caution The input and output ports of the filter cannot be reversed.

Ensure secure connection of cables to their wiring terminals.
Unitronics
Figure D
9