Mad SCIENCE The Home Lab Circuit Maze Quick Start Manual

Your Circuit Maze Kit Includes
1 Base
Assembling Your Circuit Maze
Step 1: Fit the buzzer in the
round hole in the base.
Step 2: Fit the bottom of the
wire spiral into the
square hole in the
middle of the base.
Step 3: Remove the plastic
wrap from the battery,
and slip the clip's loop
over the positive(+)
battery end.
Step 4: Put the battery into the
battery holder. Attach
the clip to the bottom
of the wire spiral.
Step 5: Connect the battery
wire to one buzzer wire.
Step 6: Connect the other
buzzer wire to the
looped wand.
Electrical plugs always have
two prongs so electricity can
flow in and out.
Make the connection!
1 Buzzer 1 Battery (AA)
(1.5 Volts)
Step 1
Step 3
Step 5
1 Wire Spiral
Step 2
Step 4
Step 6
1 Clip 1 Looped Wand