Table of Contents
Advertisement
OBSERVE GOVERNING CODES
• Observe all governing codes and ordinances.
• Installation must conform with local codes or, in the absence
of local codes, with the National Fuel Gas Code, ANSI Z223.1/
NFPA 54.
• This appliance requires connection to a 3-prong, 120VAC, 60Hz
grounded electrical source. When installed, appliance must
be electrically grounded in accordance with local codes or, in
the absence of local codes, with the National Electrical Code,
NFPA 70.
GAS SUPPLY TESTING
• The appliance and its individual shut-off valve must be discon-
nected from the gas supply piping system during any pressure
testing of that system at test pressures in excess of
• The appliance must be isolated from the gas supply piping system
by closing its individual manual shut-off valve during any pres-
sure testing of the gas supply piping system at test pressures equal
to or less than
1
/
psi (3.5 kPa).
2
• Leak testing of the appliance shall be conducted according to the
manufacturer's instructions.
IMPORTANT NOTES TO THE CONSUMER
Keep this Installation Manual with your Operation Manual for
future reference.
• When using any appliance generating heat, safety precautions
must be followed. See the Operation Manual for safety precau-
tions and follow them carefully.
• The unit must be installed and grounded properly by a qualified
installer or service technician.
• Some models of this unit come equipped for optional Wi-Fi
connection. In order to activate the Wi-Fi functionality, the area
in which the unit is installed requires a Wi-Fi signal. Please see
the Operation Manual for the minimum Wi-Fi requirements.
PARTS
Before installing, verify all parts are included. If any parts are
damaged and/or missing, contact your dealer or a Sharp Authorized
Servicer.
PART INCLUDED
Surface Burners and Caps
Surface Burner Grates
Anti-Tip Bracket
Oven Probe
Flat Rack
Gliding Rack (some models)
1
/
psi (3.5 kPa).
2
Optional Rear Trim Kit
MATERIALS NEEDED
The gas utility connection and house structure at each home may
be different, so the specific parts required for connection to the
house are not included with the product. The parts identified below
are or may be required to complete the installation. For gas supply
connections, always use new supply line and adapters and never
use an old part for new range connections.
GAS-APPROVED TEFLON TAPE
NEW FLARE UNION ADAPTER
(FOR CONCRETE FLOORS ONLY)
2
PARTS
GAS LINE
SHUT-OFF VALVE
OR JOINT COMPOUND
1
1
/
" NPT X
/
" ID
2
2
5
/
" OD SLEEVE ANCHOR
16
1
(WITH
/
" BOLT) - 2 PCS
4
QUANTITY
5
3
1 bracket, 2 screws
1
1 or 2 (depending on the model)
1
1 trim, 2 screws
NEW FLEXIBLE GAS SUPPLY LINE
3
1
1
/
" OR
/
" NPT X
/
" ID
4
2
2
3
NEW FLARE UNION ADAPTER
/
" OR
4
1
1
/
" NPT X
/
" ID
2
2
LIQUID LEAK DETECTOR OR SOAPY
WATER SOLUTION
Advertisement
Table of Contents
