Bang & Olufsen BeoLine Quick Start Guide

Connection

• Connect the cords as shown. The base indicator light (A) flashes red, indicating that the base is open for registration of handsets.
• Refer to the Guide enclosed with your handset for information about how to proceed with your handset.

If the mains adaptor is not plugged in, or if the power supply is cut off, your phone will not function. Make alternative arrangements for access to emergency services.

Feedback – indicator light

The indicator light on the base (A) informs you about the current state of the base.
The signals are explained below:
Light off... power off. Connect the base to the mains.
Solid green... power on, one or more handsets registered.
Solid red... Power on, no handsets registered.
Flashing red... Power on, base open for registration of handsets. Upon connection to the power outlet, the base is open for five minutes, after which the light shines either green or red (depending on whether or not you registered a handset in that time). If you choose to register an additional handset, a new five-minute period begins, and you can register the next handset.

Placement

To obtain the best range, place the base in a high and free-standing location, and do not mount it on a metal plate. When attaching the base to the wall bracket with the double-sided tape as shown, press the base against the wall bracket for at least ten seconds.

Do not place the base in damp, dusty or dirty environments, and do not expose it to moisture or direct sunlight. Do not place it near microwave ovens or similar appliances.

Maintenance

Use a soft, damp cloth with a few drops of mild detergent added to clean the base.

Important information about BeoLine

BeoLine is intended for use on public analogue networks. The base supports services such as Caller ID, as long as the automated service in question is offered by your telephone company. Some services require you to take out special subscriptions with the telephone company. Not all supplementary services offered by the different service providers are available in all countries.

Your base can only be expected to function in the country for which it was manufactured, as transmission systems, legal requirements and automated services may vary from country to country. The packaging will state for which country your BeoLine base is manufactured. The national identity letters can be found above the lowest bar code on the label. If you are in any doubt about the use of your BeoLine base, please contact your retailer for more information.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Bang & Olufsen BeoLine Quick Start Guide