Advertisement
Quick Links
Advertisement
Related Manuals for Ban Seok BV-322M
Summary of Contents for Ban Seok BV-322M
- Page 1 322M 322M Dispensing Valve User Manual Dispensing Valve User Manual...
-
Page 2: Table Of Contents
Contents Contents 1. Warning Report 2. Specifications 3. Install and Operating 4. Maintenance and Cleaning 5. Troubleshooting 6. Technical report Outline Dimension 3D View... -
Page 3: Warning Report
1. Warning Report 1. Warning Report Before installation and using our dispensing valve BV-300, please be fully aware of this user manual. ■ Fluid Leakage Hazard -If the fluid splashes up to your eyes or skin, it can also cause a serious injury. -Handle with extreme care not to be in contact with liquid in case of nozzle exchange or cleaning. -
Page 4: Specifications
2. Specification 2. Specification ■ 322M VALVE (Needle Type) : 322M VALVE (Needle Type) : There is no remaining pressure and very good for cutting off the There is no remaining pressure and very good for cutting off the liquid with using thin general plastic hub needles or metal need les. -
Page 5: Install And Operating
3. Install and Operating 3. Install and Operating 1.Installation 1) Connecting a Air-Pressure Line - Straightly insert the tube into the air fitting until it gets installed inside. -Pull the tube gently in order to make sure that it is safe. 2) Connecting Fluid Line - The inlet of Fluid line fits in PT1/8”... -
Page 6: Maintenance And Cleaning
3) How to Keep after Use ① To avoid a nozzle’s air contact, put an end-cap on the nozzle or keep a nozzle in the grease. ② Follow ① Cleaning of 4.Maintenance 2)Cleaning while cleaning. 4) Caution Do not exceed the liquid pressure of 40kgf/cm and the air pressure of 4kgf/cm 4kgf/cm so as to reduce the risk 4kgf/cm 4kgf/cm... -
Page 7: Troubleshooting
2. Cleaning 2. Cleaning 2. Cleaning 2. Cleaning 1) How to Clean ① Stop providing liquid and disassemble. ② Connect the cleaning line to fluid supply line and add pressure. ③ Follow the operation guide of 3-2 and dispense cleaning liquid instead of fluid. 2) Caution To minimize possible damage on skin or eyes by fluid, please strictly follow the procedure for air-release before part-replacement or valve-cleaning. - Page 8 6. Technical Data 6. Technical Data 1. Dimension 1. Dimension 1. Dimension 1. Dimension Plastic Nozzle...
- Page 9 6. Technical Data 6. Technical Data 2. 3D View 2. 3D View 2. 3D View 2. 3D View...