Advertisement
Quick Links
Advertisement
Related Manuals for Factory Furniture Serpentine Bench
Summary of Contents for Factory Furniture Serpentine Bench
- Page 1 Serpentine Bench & Seat OPERATION & MAINTENANCE MANUAL factoryfurniture.co.uk...
-
Page 2: General Specifications
Slat is profiled and left untreated as standard (oil • Manufacture or microporous woodstain treatment available on Factory Furniture manufactured components. Products request). are assembled in Factory workshops, checked and dispatched ready for installation. Replacement products Back support manufactured from stainless steel - •... -
Page 3: General Maintenance
/ sharp edges touch-up paint to match original colour (available or surfaces. from Factory Furniture Ltd). Paint application should During the first few months after installation the tannin be carried out in accordance with approved methods naturally occurring in the timber may leach out and detailed by the paint manufacturer. - Page 4 SERPENTINE BENCH & SEAT (Part No. & Item Description) X-SECTION DRAWINGS P1007 / 01 FF1007 / 04 1 no. Serpentine bench unit (complete assembled unit - SERPENTINE BENCH & SEAT not including bases) TIMBER PARTS DETAIL DRAWINGS FF1007 / 05 P1007 / 02 SERPENTINE BENCH &...
- Page 5 On-Site Assembly Instructions holes in rear seat slat and corresponding holes in back support bracket. Screw M8 lock nuts (c) onto Assembly instructions for Serpentine Bench and Seat bolts as shown. Secure front ends of back support (with back - armrests optional) brackets using 2 no.
-
Page 6: Installation Instructions
140 Ctrs using. Using a torque wrench, tighten nuts and Level Serpentine bench / seat on tubular bases washers over flange plates to 30Nm to (surface & sub-surface fix) fasten down the bench. Install suitable foundation pads (see (Sub-surface fix) Reposition bench / illustration) each with top face at ground Ø14... - Page 7 - install as complete unit. resin (or similar) Lift the bench / seat and carefully lower the anchors Serpentine bench / seat on elliptical bases into the holes, leave for two hours before using. Install suitable foundation pads (see illustration) If there are any lumps in the foundation’s surface...