Table of Contents
Advertisement
Quick Links
Document Information
Reference
USR-190017
Title
dbDualLock (S) Installation/User Guide
Synopsis
dbDualLock (S) Installation/User Guide
Author
Chris Marsden
Creation Date
2019-Mar-22
Revisions
Rev
Date
Who
001 2019-Mar-22
Chris Marsden
002 2019-Mar-26
David Montgomery
003
2019-Oct-02
David Montgomery
This manual, as well as the software described in it, is furnished under license and may be used or copied only in
accordance with the term of such license. The content of this manual is furnished for informational use only, is subject
to change without notice, and should not be construed as a commitment by Digitus Biometrics, Inc. (Digitus). Digitus
assumes no responsibility or liability for any errors or inaccuracies that may appear in this documentation. Except as
permitted by such license, no part of this publication may be reproduced, stored in a retrieval system, or transmitted, in
any form or by any means, electronic, mechanical, recording, or otherwise, without the prior written permission of
Digitus.
Document Ref
USR-190017
Notes
Initial document
Add details re: lockdown LED sequence
Fix Typo's
©2005-2019 Digitus Biometrics, Inc. All rights reserved.
Document Title
dbDualLock (S) Installation/User Guide
Page
1 of 14
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Digitus USR-190017
Summary of Contents for Digitus USR-190017
- Page 1 The content of this manual is furnished for informational use only, is subject to change without notice, and should not be construed as a commitment by Digitus Biometrics, Inc. (Digitus). Digitus assumes no responsibility or liability for any errors or inaccuracies that may appear in this documentation. Except as...
- Page 2 Tri color (Red / Amber / Green) Reader LED Tri color (Red / Magenta / Blue) Status LED Secure key-cylinder. Optical Handle Compatible with ultra- Position Sensor secure cylinders Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 2 of 14...
-
Page 3: Table Of Contents
RFID Configuration Card..............................12 Reader LED .................................... 13 Connected to dbSentry or dbRemote Node ........................13 Connected to an Access Control Panel ..........................13 Status LED ..................................... 14 Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 3 of 14... -
Page 4: Dbduallock (S) Installation
Edge of Door Frame to Center of Handle Rear surface of handle to Inside of Door Frame In most situations the pawl from the existing mechanical handle can be re-used with the new lock. Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 4 of 14... -
Page 5: Mounting The Dbduallock (S)
Secure the dbMultiCardLock (S) to the door using the top and bottom mounting brackets, being careful not to over tighten the screws as this could cause the lock mechanism to jam. Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 5 of 14... -
Page 6: Installing The Rotation Limiter
Installing the Rotation Limiter Figure 2 – Rotation Limiter Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 6 of 14... -
Page 7: Positioning The Tie-Down Pads
Figure 3 – Positioning the tie-down pads Remove the protective cover from each tie-down pad and situate as shown in Figure 3. Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 7 of 14... -
Page 8: Routing The Lock Cable
Route the lock cable to the door hinge as illustrated below and secure the cable to the tie-down pads using the supplied cable-ties. Connect the supplied device cable to the RJ-45 coupler and route it to: the Remote Node or Sentry (if you are using Digitus a controller) 3 Party Access Panel (if you are connecting to a third-party access control panel, connect a network cable to RJ- 45 coupler and run back to panel. -
Page 9: Connecting To Dbremote Node / Dbsentry
For clarity and consistency, it is recommended that for a cabinet with 2 doors, the front door is connected to Dev 1 and the back door is connected to Dev 2. Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 9 of 14... -
Page 10: Connecting To 3 Rd Party Access Panels
Will be open circuit if the handle is open. See diagram below Green GREEN LED Brown / White DATA1 Wiegand Data 1 Brown DATA0 Wiegand Data 0 Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 10 of 14... -
Page 11: Rd Party Panel
If the 3rd-party Access Panel requires a 2-wire input to monitor the handle position, an external 12v low current relay is required. The diagram below shows how to connect the "LATCH POS" signal to a 3rd-party Access Panel with a relay. Approved relays can be purchased by contacting your Digitus vendor or by emailing sales@digitus-biometrics.com Figure 8 –... -
Page 12: Power Up
Connected to a 3 -party Access Panel If a Digitus Support Technician advises that your handle requires a firmware update, Digitus will ship a loan programmer which, once connected directly to your handle, will update the firmware. Configuration Cards Handle Configuration Card There may be instances where the operational aspects of the handle need to be changed. -
Page 13: Reader Led
If an unknown/invalid card is presented or authentication to the card failed the handle LED will turn solid for 3 seconds and access is denied. If the handle is in “Lockdown” mode, the handle LED will alternate between AMBER until “Lockdown” is cancelled. Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 13 of 14... -
Page 14: Status Led
When the dbDualLock (S) is locked, the handle is closed, but not fully engaged and therefore still unsecure the Status LED will flash BLUE / RED. Document Ref Document Title Page USR-190017 dbDualLock (S) Installation/User Guide 14 of 14...
Need help?
Do you have a question about the USR-190017 and is the answer not in the manual?
Questions and answers