Download Print this page

Kohler Stargaze K-1958-GHW Manual page 2

72" x 36-1/4" freestanding heated bubblemassage air bath with bask™ heated surface and straight shroud

Advertisement

No change in measurements if connected with drain illustrated. (K-37386)
Recommended Faucet Location
4-1/4"
(108 mm)
Lumbar
Angle 21°
25"
(635 mm)
3-1/2"
(89 mm)
Required Electrical Service
Two dedicated circuits required, protected with Class A Ground-
Fault Circuit-Interrupter (GFCI). Outside North America, this
device may be known as a Residual Current Device (RCD).
Blower, Heated
120 V, 15 A, 60 Hz
Surface:
Heater:
120 V, 15 A, 60 Hz
Technical Information
All product dimensions are nominal.
Installation:
Freestanding
Drain location:
Center
Basin area, bottom:
50-3/4" x 24-7/8" (1289 mm x 632 mm)
Basin area, top:
67-9/16" x 29-3/16" (1717 mm x
741 mm)
Weight:
91 lbs (41.3 kg)
Minimum floor load:
45 lbs/ft² (219.7 kg/m²)
Water depth:
15-11/16" (399 mm)
Water capacity:
90 gal (340.7 L)
Template:
Footprint, 1245664, not required, not
included
1-800-4KOHLER (1-800-456-4537)
Electrical component
Blower: 120 V, 10 A, 60 Hz
Kohler Co. reserves the right to make revisions without notice to product specifications.
rating:
Heated Surface: 120 V, 0.5 A, 60 Hz
For the most current Specification Sheet, go to www.kohler.com.
Heater: 120 V, 5 A, 60 Hz
4-18-2023 23:36 - US/CA
72" x 36-1/4" freestanding Heated BubbleMassage™
air bath with Bask™ heated surface and straight
36" (914 mm)
72" (1829 mm)
1-1/2" Bath Drain
66-7/8" (1699 mm)
4"
(102 mm)
Recommended Faucet Hole Location
19-1/4"
(489 mm)
3-3/4"
35-7/8" (911 mm)
(95 mm)
17-3/8"
(441 mm)
29-7/16" (748 mm)
15-15/16"
(405 mm)
Notes
Measure your actual product for rough-in
details.
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
This bath is designed for freestanding
installation only.
If installing a rim-mount faucet, make sure there
is no interference above or below the deck
before drilling any holes.
Stargaze™
shroud
K-1958-GHW
4"
9-5/16"
(102 mm)
(237 mm)
3"
(76 mm)
1/2"
(13 mm)

Advertisement

loading