Cleaning And Maintenance - Jimmy GT306 Instruction Manual

Cleaning and Maintenance

Clean the residual water between the water tank and the host to prevent scale.
When the steam amount is significantly less than before or steam flow stops shortly after
working, please remove the scale accumulated on the heater of the garment steamer. We
suggest that you remove the scale according to the following methods:
1.Turn off the garment steamer and unplug the power supply, take out the supporting pole and
remove it from the main machine;
2.When the garment steamer is cooled to room temperature, remove the water tank from the
main machine and drain the remaining water in the machine;
3. Mix white vinegar and water in 1:1 ratio (if scale is too much, please increase the proportion
of white vinegar as appropriate). If you have no white vinegar, you can use other detergent
which can remove scale;
4.Slowly pour the mixture into the water tank then put the water tank into the machine, the
mixture shalll not overflow;
5.Soak for 1-2 hours at room temperature (please extend the soaking time if there is much
scale, but do not exceed 8 hours);
6.Pour the mixture out of the water storage sink and the round outlet on the machine.
7.Fill the water storage sink with water and pour it out. Repeat injection of clean water to wash,
until the scale and acid flavour inside the machine is gone;
8. Reassemble the parts so that they can be used again.
Notes
Please read this instruction carefully before using this machine and keep it for future reference.
This product is only for indoor use, please do not put the machine on the table, the work table or
other high table surface to use, please put the machine on the level ground.
Please do not allow children or people with no independent behavior ability or lack of relevant
experience to use this product alone to avoid the risk.
When using this product, please use the power supply with 30mA leakage protection switch.
Be careful of condensed hot water to prevent scalding.
Do not add water after starting the power to prevent dry burning.
Do not add hot water to the water tank as this will cause the tank to deform.
Do not add cleaning agent or other solutions into the water tank. Do not pour perfume, vinegar,
starch, scale remover or other chemicals into the water tank.
23