Table of Contents
Advertisement
Sequential Play
1
OPEN
Label must face upward.
Close the lid.
2
R
L
1
Slide [OPEN1] to open the lid, and
insert the disc.
2
Connect the wired remote control
and the stereo headphones to [Ë].
(Plug in firmly.)
3
Release [HOLD].
4
Press [ 1/; ] (main unit) or press
[ ∫/1 ] (remote control) to start play.
≥The music symbols flash randomly during play.
≥Play stops automatically when all the tracks
have been played.
5
Adjust the volume.
i : To increase the volume level
j : To decrease the volume level
≥The volume range is 0-25. (Press and hold to
change the volume successively.)
≥A tone (beep-beep) sounds when you reach the
minimum or maximum volume when using the
remote control.
≥The volume changes when pressed while the
level is displayed. If any other display is shown, it
changes to show the current level.
∫ To pause play
(main unit only)
Press during play. (Press again to restart play.)
∫ To stop play
Stop mode
Press during play.
Main unit
Remote control
(Beep...Beep)
Resume function
The unit stores the track where you stopped play and if
you press [1/;] (main unit) or [∫/1] (remote control),
play resumes from the beginning of that track.
3
Basic Play
Plug type:
3.5 mm (1/8 in.) stereo
Resume function notes
≥Opening the lid while stopped or replacing the disc
while off cancels the function. (It may remain active if
you replace a disc in the off mode.)
≥Play may resume from the beginning of the next track
if you stopped play near the end of a track.
≥The resume function is automatic and you cannot turn
it off.
∫ To turn off the unit
Press while stopped (main unit) or press and hold
while playing or stopped (remote control).
Main unit
∫ Skip / Search function
Skip : Press during play. (Press [ : ] twice to skip
Search : Press and hold during play.
Main unit
Forward
Backward
≥During program play (page 4), these buttons are used
to skip forward or backward through the programmed
sequence of tracks.
≥You cannot skip to tracks that have been played in
Total number of tracks
random or random repeat play (page 4).
≥During program play, 1-track repeat play, random play
and random repeat play (page 4), search operation is
limited to the current track only.
Total playing time
CD-R and CD-RW discs
This unit can play CD-DA (digital audio) format
audio CD-R and CD-RW that have been finalized (a
process that enables CD-R and CD-RW players to
play audio CD-R and CD-RW) upon completion of
recording. It may not be able to play some CD-R/
CD-RW due to the condition of the recording.
N
O P E
3
HOLD
Off mode
Remote control
No indicator
is shown.
(Beep...Bee...p)
to the beginning of the previous tracks.)
Remote control
Forward
(Beep Beep)
(Beep Beep Beep)
Backward
5
4
Track number in play
EQ
HOLD
Elapsed playing time of each track
HOLD
For your reference:
"
" indication
This indication appears for about 30 seconds if you
press [1/;] (main unit) or [∫/1] (remote control)
when no disc is loaded or if the disc is not properly se-
cured.
"
" indication
This indication appears for about 10 minutes when you
open the lid (unless the unit is off).
Removing discs
1
Press [∫] to stop play and disc rotation.
2
Slide [OPEN 1] to open the lid.
3
Press [PUSH] to release the disc.
Do not stop the disc by hand or try to remove it before it
stops rotating. This can damage CDs.
Note!
Never insert foreign objects into the unit.
Auto-off function
To save batteries, the unit turns off after about 10 min-
utes after being stopped (30 seconds if a disc is not
loaded).
Operation confirmation tones
This tone sounds when a button on the remote con-
trol is pressed. Refer to the parentheses in the illus-
tration for the different types of confirmation tones.
∫ Turning the operation tones off and on
»
While stopped or during play
»
Press and hold [EQ] on the remote control for 5 sec-
onds until the display appears. The tone sounds
when the setting is changed.
EQ
HOLD
To turn the tone off
VOL
(Beep)
(Beep)
(Beep)
EQ
(Beep)
To turn the tone on
Advertisement
Table of Contents
