Table of Contents
Advertisement
Sequential Play
4
Track number in play
Elapsed playing time of each track
Follow steps 1–5.
In step 2: Connect the stereo headphones and wired remote control to the headphone jack [Ë]. (Plug in firmly.)
In step 5: The volume range is 0-25. Press and hold to change the volume successively. The volume changes when
pressed while the level is displayed. If any other display is shown, it changes to show the current level.
(The volume returns to 10 when you disconnect the power source.)
≥Play stops automatically when all the tracks have been played.
≥If the unit has been connected to the car audio system, set this unit's volume to 10, then adjust the volume level on
the system.
Operation
Press during play.
To pause play
Press during play.
To stop play
Stop mode
Press during stop mode.
To turn off the
unit
Off mode
Press during play.
Skip forward/
(Press [:] twice to skip to the
backward
beginning of the previous tracks.)
(skip function)
Backward
Rapid forward/
backward
(search function)
Press and hold during play.
For your reference:
"
" indication
This indication appears for about 30 seconds if [1;] (main unit) or [∫/1] (remote control) is pressed when no disc
is loaded in the unit or if the disc is not properly secured.
"*" indication
This indication appears for about 10 minutes when the lid is opened. (However, the indication does not appear when
the unit is powered off.)
3
Basic Play
VOL
S-XBS
TRAIN
C
M
ALL
1
RANDOM
SORRY
3
HOLD
Button
Total number of tracks
≥During program play (page 4), these buttons are
used to skip forward or backward through the
programmed sequence of tracks.
≥You cannot skip to tracks that have been played
in random or random repeat play (page 4).
≥During program play, 1-track repeat play, random
play and random repeat play (page 4), search op-
eration is limited to the current track only.
Forward
5
Plug type:
3.5 mm (1/8 in.) stereo
Display/reference
Press again to restart play.
VOL
S-XBS
TRAIN
C
ALL1
M
VOL
C
S-XBS
TRAIN
ALL
1
M
RANDOM
Total playing time
VOL
C
S-XBS
TRAIN
ALL1
M
VOL
C
VOL
Increase
SORRY
1
Decrease
Label must face upward.
2
Close the lid
R
L
Resume function
The player stores the track where you stopped play and
if you press [1 ;] (main unit) or [∫/1] (remote control),
play resumes from the beginning of the track.
The resume function is canceled (play starts from the
first track) if you open the lid when the unit is in stop
mode. It is also usually canceled when you replace the
CD while the unit is off.
Note!
≥The resume function may work if you replace the CD
while the unit is off.
≥If you turned the unit off near the end of the track, play
may resume from the beginning of the next track.
≥The resume function works automatically and cannot
be turned off.
Removing discs
1
Press [∫,OPR OFF] to stop play and disc
rotation.
2
Slide [OPEN 1] to open the lid.
3
Press [PUSH] to release the disc.
Do not stop the disc by hand or try to remove it before it
stops rotating. This can damage CDs.
Note!
Never insert foreign objects into the unit.
Auto power off function
If the unit is left in stop mode for approximately 10 min-
utes, the unit powers itself off automatically in order to
prevent the battery from running down.
(If no disc is loaded in the unit, it powers itself off in
about 30 seconds.)
Note on CD-R and CD-RW
This unit can play CD-DA format audio CD-R and
CD-RW that have been finalized
of recording. It may not be able to play some CD-R
or CD-RW due to the condition of the recording.
Finalizing is a process that enables CD-R/CD-RW players
§
to play audio CD-R and CD-RW.
VOL
S-XBS
TRAIN
ALL
1
M
RANDOM
OPEN
upon completion
§
Advertisement
Table of Contents
