Pendix eDrive300 System Instruction

Pendix eDrive300 System Instruction

Hide thumbs Also See for eDrive300:

Advertisement

Quick Links

System instruction
Pendix eDrive
compatible with
Pendix.bike PRO App
valid only in combination with original bicycle operating instructions

Advertisement

Table of Contents
loading

Summary of Contents for Pendix eDrive300

  • Page 1 System instruction Pendix eDrive compatible with Pendix.bike PRO App valid only in combination with original bicycle operating instructions...
  • Page 2: Table Of Contents

    Contents General Safety Notes ......... . 3 Introduction .
  • Page 3: General Safety Notes

    Do not allow children to use the Pedelec unat- Dear Sir or Madam, by attaching the Pendix eDrive system to Danger: This symbol stands for a possible dan- tended and without proper previous instruction! your bicycle, you will be assisted in riding with an electric drive.
  • Page 4: Notes On Electrics And

    Please never ride or roll standing on one side of unit of your Pendix eDrive and how to ride a Pedelec. General 3. Notes on electrics and a pedal! information, e.g. on bicycle technology, can be found in the en- closed instructions.
  • Page 5: Configuration Of The Product

    Improper and unprofessional operation of the motor and manipulations to battery, charging unit and motor involve great danger to health and damage of material. In any such cases, Pendix refuses to accept any responsibility for dam- age or accidents caused. Pendix eDrive system...
  • Page 6: Overview Components

    Crank length: 172.5 mm Pedal threat: 9/16“ x 20 RH (FG 14.3) Connection diameter chain wheels: 104/64 mm Bottom bracket unit Pendix bottom bracket Assembly set wheel speed sensor Square shaft Wheel speed sensor Shaft length: 128 mm Mounting kit wheel speed sensor Bottom bracket thread: BSA 1.375“...
  • Page 7: Emachine

    Avoid contact. If you do come into contact with the battery liquid, wash the affected area with If you want to use a gear hub with the Pendix Safety notes plenty of water. If it comes into contact with your eyes, eDrive, please make sure that the circuit for the find a doctor or medical expert immediately for help.
  • Page 8: Charging Unit

    The battery charge voltage must • This battery is designed only for use with Pendix elec- be the same as that of the charging unit. Other- tric bicycle motors. Improper use or incorrect handling wise, a fire or an explosion may result.
  • Page 9: Operation

    Riding without the motor is possible, both with or with- With the Pendix eDrive it is possible to choose between the 6. Operation out the battery installed. If the battery is used, but there is operational profile "Efficiency" and "Performance" (profile no LED display, this means that the motor is deactivated as supplied to customer) using the Pendix.bike PRO App.
  • Page 10: Connecting Epower With Charging Unit

    6.4 Connecting ePower with charging unit You can recharge the battery at any time without shortening It is possible to turn off the pulsing of the LED display during When using the Power Station, just make sure the dot on its life.
  • Page 11: Additional Functions

    4 seconds, afterwards the LED display starts to to Eco. Push the ON/OFF button down for 4 seconds, after In its lower section, the Pendix battery has been fitted with a blink red which signals that the battery is ready for connec- which the LED display begins to show brightness levels in 5 withdrawable safety lock.
  • Page 12 The displayed range data refers to the riding profile "performance" which is preset from the factory. You however are phy, frequency of starts able to choose the riding profile "efficieny" in the Pendix.bike PRO App in order Bicycle influences such as tire width, tire profile, to generate a even higher range.
  • Page 13: In Case Of An Error

    8. In case of an error Should your Pendix eDrive not function any more, this can You can use the Pendix.bike PRO App to read out the existing Repairs on the motor may only be carried out by have different reasons. The following signals have been error.
  • Page 14: Transporting Your

    Overall system Using a suitable attachment to your car (bike rack), you can gearless mid-mounted System weight 6.9 kg (eDrive300) Motor always transport your Pedelec in the same way as a bicycle. motor 7.3 kg (eDrive500) • Note: as the Pedelec weighs more than a normal bicycle,...
  • Page 15: Guarantee Conditions

    Warranty regulations can be found at: tac.pendix.com The guarantee regulation can be found at: • Austria: https://pendix.at/garantie • Switzerland: https://pendix.ch/garantie • Belgium: https://pendix.be/garantie or https://pendix.be/en/warranty • Netherlands: https://pendix.nl/garantie or https://pendix.nl/en/warranty • all other countries: https://pendix.com/warranty 13. Imprint Responsible for content and illustrations Pendix GmbH Innere Schneeberger Straße 20...
  • Page 16 System instruction EN A3D.705.002-R02-CN21.322.001 This Pendix eDrive was assembled by: Pendix GmbH Innere Schneeberger Straße 20 08056 Zwickau Germany www.pendix.com...

This manual is also suitable for:

Edrive500Edrive1000

Table of Contents