Installing the Input Adaptor
3
Installing the Power
Block
1
4
Remove the screw (PS3×8) to
remove the power block shield
case.
2
Hook the power block (the shield
case has been removed) on the G
board shield case (see figure).
Lock the power block with the
screw (3×8) (supplied).
Screw PS3×8
Screw 3×8 (supplied)
Shield case
1
2
G board
Power block
16
Install the power block shield case
removed in Step 1. Lock the case
with the screw.
Lock the power block cables
(black/white and black/red) with
the two purselocks (see figure).
Connect the cable (black/white) to
the CN610 connector on the G
board.
CN610
Purselocks
3
Installing the GC board
Note
Install the GC board after you have
installed the power block.
1
Slide and pull out the main
bracket.
2
Lift and remove the shield case lid
(left-front of the A board).
2
1
Shield case
Main
A board
lid
bracket
Insert the board holders (supplied)
into the four holes in the shield
case. Match the board holders
and the holes of the GC board,
insert the GC board into the holes.
GC board
Board
holders
(supplied)
(4)
(Continued)
17