Rear Panel - Panasonic Comcast TZ-PCD3000 Operating Instructions Manual

Rear Panel

1 2
CABLE IN
OUT2
R-AUDIO-L VIDEO
CABLE OUT
R-AUDIO-L
VIDEO
OUT1
6
7
Use to connect Cable Signal input from Cable
1
CABLE IN
Service Provider.
Use to connect the Digital CATV Terminal out-
2
CABLE OUT
put to your TV or VCR.
The COAXIAL S/PDIF connector is a digital out-
DIGITAL AUDIO
3
COAX OUT
put connection that carries Dolby Digital (up to
5.1ch) audio or PCM audio.
Use to connect a peripheral equipment to the
USB Port
4
(Universal Serial Digital CATV Terminal.
Bus)
3 4
5
COAX
OUT
DIGITAL
AUDIO
OPT
USB SERIAL
S-VIDEO IR
OUT
BLASTER
8 10
12
11
9
AC Switched
5
Outlet
6
AUDIO OUT
SWITCHED AC OUT
120V~60Hz 5A
AC IN
120V~60Hz
7
VIDEO OUT
8
S-VIDEO OUT
DIGITAL AUDIO
9
OPT OUT
10
IR BLASTER
11
SERIAL port
12
AC Power Input
Use to connect the power cord plug of some
other component such as a TV.
(120 V AC, 60 Hz, 5 A)
Please use within specification.
Use to connect the Digital CATV Terminal au-
dio output to your TV with stereo sound, or VCR
with stereo sound.
Note:
AUDIO OUT1 is for TV, and the volume is variable.
AUDIO OUT2 is for VCR, and the volume is fixed
Use to connect the Digital CATV Terminal video
output to your TV or VCR.
Use to connect the Digital CATV Terminal S-
video output to your TV with S-VIDEO, or VCR
with S-VIDEO.
The OPTICAL S/PDIF connector is an optical
digital output connection that carries Dolby Digi-
tal (up to 5.1ch) audio or PCM audio.
When an IR BLASTER cable unit is connected
to this terminal, this terminal can output remote
control signals for recording images from a video
deck that is connected to the Digital CATV Ter-
minal
This terminal can be used to send and receive
data between the Digital CATV Terminal and
other equipment.
(do not connect your PC to this SERIAL port.)
Use to connect the Digital CATV Terminal to an
AC electrical outlet with AC cord (included).
.