Husqvarna WS 482 HF Operator's Manual page 12

6. Examine which of the holes on the blade flange hub
that is to be used.
A M10
B M8
7. Remove the 6 plugs from the M8 or M10 screw
threads on the blade flange hub.
1675 - 001 - 11.06.2021
A
B
110 mm
89 mm
8. If the flush cutting blade with 25.4 mm/ 1 in. center
holes (C) is used, remove the 60 mm/2.35 in. spacer
(D).
9. Assemble the flush cutting blade on the blade flange
hub.
E
10. Install the 6 flush cutting screws M8 or M10 (E). Use
tightening torque 30 Nm.
11. Assemble the product on the rails. Refer to
assemble the product on the rails on page 9 .
12. Make sure that the blade is correctly attached before
you start the product.
13. Install the flush cutting guard.
14. Connect the water hose from the outlet on the saw
motor to the inlet on the blade flange hub.
D
C
To
11