Stereo Radio Cassette Player
Before connecting, operating or adjusting this product,
please read these instructions completely.
Please keep this manual for future reference.
Press in and
the - end.
Two R6/LR6, AA, UM-3
batteries (not included)
Plug in firmly.
Plug type:3.5mm (
You can use normal type tapes only. This unit will not be able to do full justice to characteristics of high and metal position
tapes even if they are played back.
To fast forward or rewind
[DIR] switched to [FWD]: In the stop mode, press  (fast forward) or  (rewind).
[DIR] switched to [REV]: In the stop mode, press  (fast forward) or  (rewind).
Reverse tape direction
In the stop mode or during playback, set [DIR] to [REV] or [FWD].
Press [∫] to stop the tape before operating the radio. While playing a tape, the radio will not turn on even if you press
Remove the head spacer.
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of
One Panasonic Way Secaucus, New Jersey 07094
Panasonic Sales Company, Division of
Matsushita Electric of Puerto Rico, Inc. ("PSC")
Ave. 65 de Infantería, Km. 9.5 San Gabriel Industrial
Park, Carolina, Puerto Rico 00985
©2003 Matsushita Electric Industrial Co., Ltd.
Printed in Taiwan
Press and hold
SELECT THE STATION.
During playback, press [∫].
During reception, press [RADIO ON/OFF].
1 Stereo headphones . . . . . . . . . . . . . . RFEV705P-KY
2 Belt clip . . . . . . . . . . . . . . . . . . . . . . . . . RKQT0008-A
To order accessories contact 1-800-332-5368 or web
≥Use numbers indicated when asking for replacement
Attaching the belt clip
Belt clip (included)
ADJUST THE VOLUME.
No tape operations in spite
of radio operations.
No radio operations.
≥A gritty noise is heard.
Cannot hear music - too noisy.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
≥Reorient or relocate the receiving antenna.
≥Increase the separation between the equipment and receiver.
≥Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
≥Consult the dealer or an experienced radio/TV technician for
Any unauthorized changes or modifications to this equipment
Detaching the belt clip
would void the user's authority to operate this device.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
Before requesting service, make the below checks. If you are in doubt about some of
the check points, or if the remedies indicated in the chart do not solve the problem,
contact the Panasonic Customer Call Center at 1-800-211-7262, or e-mail
firstname.lastname@example.org, or web site (http://www.panasonic.com).
Are the batteries worn?
≥Is the unit in the hold state?
≥Is a tape playing?
Have the batteries been installed with their polarities
(+, -) reversed?
≥Is the headphone plug firmly connected to the [Ë] jack?
≥Is the plug dirty? (Wipe away the dirt on the plug.)
Separate the unit from mobile phones.
[DIR] switched to FWD