Setting Up Anynet; Scanning And Switching Between Anynet+ Devices - Samsung 4 Series User Manual

Setting Up Anynet+

The following settings are to use Anynet+ functions.
Using the Anynet+ Function
1 Press the Anynet+ button.
Press the ▲ or ▼ button to select Setup, then press the
ENTER/OK button.
 Press the ENTER/OK button to select Anynet+ (HDMI-CEC),
then press the ENTER/OK button.
 Press the ▲ or ▼ button to select On, then press the ENTER/
OK button.
➢
The Anynet+ (HDMI-CEC) function is enabled.
➢
If you select Off, Anynet+ (HDMI-CEC) is disabled.
➢
When the Anynet+ (HDMI-CEC) function is disabled, all the
Anynet+ related operations are deactivated.
Turning an Anynet+ Device Off Automatically when the TV is Turned Off
 Press the ▲ or ▼ button to select Auto Turn Off, then press
the ENTER/OK button.
 Press the ▲ or ▼ button to select On, then press the ENTER/
OK button.
➢
The Auto turn off function is enabled.
➢
If you select Off, the Auto turn off function is canceled.
Press the EXIT button to exit.
➢
The Select Device setting of the TV remote control is to be set
to TV to use the Anynet+ function.
➢
If you set Auto Turn Off to On, connected external devices are also turned off when the TV is turned
off. However, if the device is recording, it may not be turned off.

Scanning and Switching between Anynet+ Devices

1 Press the Anynet+ button.
 Press the ▲ or ▼ button to select Select Device, then press
the ENTER/OK button.
 Press the ▲ or ▼ button to select to a particular device and
press the ENTER/OK button.
It is switched to the selected device.
4 If you cannot find a device you want, press the ▲ or ▼ button
to select Searching Connections, then press the ENTER/OK
button.
The meassage Configuring Anynet+ connection... is
displayed. When searching devices completes, the connected
devices are listed in the Anynet+ menu.
➢
Switching to the selected devices may take up to 2 minutes.
You cannot cancel the operation during the switching
operation.
➢
The time required to scan for devices is determined by the
number of connected devices.
➢
When the device scan is complete, the number of found
devices is not displayed.
➢
Although the TV automatically scans devices when it is turned
on using the POWER button, devices connected when the TV is on or under a specific circumstance
are not displayed in the device list. Therefore select Searching Connections menu to search
devices.
➢
If you have selected external input mode by pressing the SOURCE button, you cannot use the
Anynet+ function. Make sure to switch to an Anynet+ device by using the Anynet+ button.
English - 4
TV P 1
View TV
Select Device

Record

Menu on Device

Device Operation

Receiver :Off

Setup

Move Enter
Exit
Setup
Anynet+ (HDMI-CEC) : Off
Off
Auto Turn Off : Off
On
Searching Connections
Move Enter
Setup
Anynet+ (HDMI-CEC) : On
Auto Turn Off : Off
Off
Searching Connections
On
Move Enter
TV P 1
View TV
Select Device

Record

Menu on Device

Device Operation

Receiver :Off

Setup

Move Enter
Return
Setup
Anynet+ (HDMI-CEC) : On
Auto Turn Off : On
Searching Connections
Move Enter
Return
Return
DVDR1
DVDR
DVD1
DVD



Return
Continued...