Advertisement
REMOTE CONTROLLED MOTION
GETTING STARTED GUIDE
5a. Use - Alarm + Light
If the unit is switched to "Alarm + Light",
25 seconds after it is turned on the
alarm will be armed. This allows you
time to arm and then leave a room. The
alarm will activate and the red LED light
on the front of the unit will flash for 30
seconds after detecting motion. The
alarm can be turned off by pressing the
"Disarm" button on the remote.
5b. Use - Light
If the unit is switched to "Light", it will
immediately light up when detecting
motion in low light/dark conditions.
In bright conditions the PIR Sensor
light will not illuminate when motion is
detected.
6. Switch Off when not in Use
a. Once finished with the Motion Detector, ensure
you turn the unit off using the switch on the side.
Note: If you will not be using the Motion Detector
for an extended period, remove the batteries before
storing.
DETECTOR WITH LIGHT
Model Number: IT414071D
5
Switch on the Right
Hand Side of the
Motion Detector unit.
Advertisement
