Bosch TASSIMO TAS 65 Series Instruction Manual page 38

36
Problem
Automatic mode
O
not working, appliance
remains in stand-by
mode.
Automatic mode
O
skipped, appliance
goes straight to
Manual mode.
N
The quality of
the crema has
deteriorated.
Brewing unit cannot be
securely closed.
Water dripping from
the brewing unit.
Water on the surface
under the cup stand.
More Customer Service information is available online at www.tassimo.com
Robert Bosch Hausgeräte GmbH
01_TAS 65_85_Heft1.indb 36
Possible!cause
No T DISC inserted.
The barcode could not be
detected.
The barcode could not be
detected.
The drink outlet is clogged or
dirty.
Piercing unit / T DISC holder is
not properly inserted.
The T DISC is not inserted
properly.
The brewing unit is not
properly closed.
The T DISC is damaged or
leaky.
The piercing unit is either
not inserted or not inserted
properly.
Water from condensation.
Solution
Check if T DISC has been
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline.
08 00 032 88 33 (UK only).
Clean the bar code reading
window.
Use another T DISC.
You can still prepare the drink
by holding down the start / stop
button.
Remove the drink outlet
from the brewing unit and
detach the piercing unit.
After cleaning everything
thoroughly, reassemble the
parts and replace them in the
brewing unit.
Insert the T DISC holder and
piercing unit properly.
Re-insert the T DISC and
make sure it is properly
positioned.
Push the clamp down irmly
until it audibly clicks into place.
Stop the brewing process,
remove the T DISC and clean
the brewing unit.
Check to ensure that the
piercing unit is inserted
properly.
Condensation may occur and
is not a fault. Remove it by
wiping with a cloth.
en
09.05.2011 09:32:40