Panasonic CQ-2130 Operating Instructions Manual page 18

Installation
❐ Preparation
Warning: If your vehicle is equipped with air bag
and/or anti-theft systems, specific procedures may
be required for connection and disconnection of the
battery to install this product.
Before attempting installation of this electronic com-
ponent, contact your vehicle dealer or manufacturer
to determine the required procedure and strictly fol-
low their instructions.
FAILURE TO FOLLOW THE PROCEDURE MAY
RESULT IN THE UNINTENDED DEPLOYMENT OF
AIR BAGS OR ACTIVATION OF THE ANTI-THEFT
SYSTEM RESULTING IN DAMAGE TO THE VEHICLE
AND PERSONAL INJURY.
• Disconnect the cable from the negative
minal (see warning and caution below).
• Remove Mounting Collar q from the main unit tem-
porarily, which are already mounted at shipment.*
Caution: Various settings that have been stored in
the memory in other on-board equipment (vehicle
navigation etc.) may be lost if the battery terminals
are disconnected.
Therefore, we recommend to make a record of or to
back up the settings before disconnecting the termi-
nals.
After completing installation of the main unit, set the
equipment again according to the record.
• Unit should be installed in a horizontal position with
the front end up at a convenient angle, but not more
than 30˚.
❐ Dashboard Installation
Installation Opening
This unit can be installed in any dashboard having an
opening as shown below. The dashboard should be
3/16" (4.75 mm) – 7/32" (5.56 mm) thick in order to be
able to support the unit.
18
CQ-2130U
(Continued)
battary ter-
❐ Installation Hardware
No. Item
q
Mounting Collar*
w
Plain washer (5mmø)
e
Spring Washer (5mmø)
r
Hex. Nut (5mmø)
t
Rear Support Strap
Hex. Bolt
y
(5mmø × 25 mm)
Toothed Lock Washer
u
(5mmø)
Removal Tool
i
(U-shaped)
o
Antenna Connector
(a) Using the rear support strap t
(b) Using the rubber cushion (option)
Rubber cushion (option)
q Mounting collar
Diagram Q'ty
1
2
2
2
1
1
1
2
1
Rear support bracket
(provided on the vehicle)
Mounting bolt
(5 mmø)