Chevrolet Silverado 2500 HD 2024 Owner's Manual page 247

When towing a trailer with ACC, it is
important to properly set the Trailer Gain.
See Integrated Trailer Brake Control
System in Towing Equipment 0 278 for
Trailer Gain Adjustment Procedure.
Use Tow/Haul mode when driving down
steep hills or mountain grades, or when
hauling heavy loads. See Driver Mode
Control 0 232.
Disengaging ACC
There are three ways to disengage ACC:
Step lightly on the brake pedal.
Press .
Press .
Erasing Speed Memory
The ACC set speed is erased from memory if
is pressed or if the ignition is turned off.
Weather Conditions Affecting ACC
If the interior temperature is extremely
high, the instrument cluster may indicate
that ACC is temporarily unavailable. This can
be caused by extreme hot weather
conditions with direct sunlight on the front
camera. ACC will return to normal operation
once the cabin temperature is lower.
Conditions that are associated with low
visibility, such as fog, rain, snow, or road
spray, may limit ACC performance. Water
droplets from rain or snow that remain on
the windshield may also limit ACC s ability
to detect objects.
System operation may be limited under
snow, heavy rain, or road spray conditions.
Warning
Camera visibility may be limited and the
ACC system may not work properly if the
windshield is not clear. Do not use ACC if
moisture is present on the inside of the
windshield or the windshield washer is
used in cold weather. Turn on the front
defroster and make sure the windshield is
clear before using ACC. Before driving,
check that the windshield wipers are in
good condition and replace them if worn.
Lighting Conditions Affecting ACC
The ACC front camera can be affected by
poor lighting conditions, and ACC may have
limited performance when:
There are changes in brightness, such as
entering and exiting tunnels, bridges, and
overpasses.
Driving and Operating
Low sun angles cause the camera to not
detect objects, or it is more difficult to
detect objects in the same traffic lane.
Lighting is poor in the evening or early
morning
There are multiple changes in brightness
or shadows along the vehicle roadway.
In a tunnel without the headlamps on,
or in a tunnel when there is a vehicle in
front that does not have its taillamps on.
Subjected to strong light from opposing
lane traffic in the front of the vehicle,
such as high-beam headlamps from
oncoming traffic.
Accessory Installations and Vehicle
Modifications
Do not install or place any object around
the front camera windshield area that would
obstruct the front camera view.
Do not install objects on top of the vehicle
that overhang and obstruct the front
camera, such as a canoe, kayak, or other
items that can be transported on the
vehicle roof.
Do not modify the hood, headlamps, or fog
lamps, as this may limit the camera s ability
to detect an object.
245