sylvansport GO Camper Quick Setup Manual

SylvanSport GO Camper Quick Setup Guide

Raising the Tent Pod

● Detach GO from vehicle and level front to back using the dolly jack.
● Level left and right using stabilizer jacks.
● Remove 4 pins to release the equipment rack.
● Raise the equipment rack/tent pod using the crank handle or drill adapter.
● Insert the 4 bed support poles long grey bag into place.
● Remove the velcro straps from the front and back of the bed platforms.
● Grab the bed platform by the center weld, raise up and over the pins and insert the support poles into the platform. Twist a
quarter turn to ensure they are locked into place. Repeat on the other side.
● Lower the tag holder to convert into the entry step.
● Place the Picnic Pad/Deck Cushion on the diamond plate deck.

Setting Up the Tent

● Open the bottom of the tent pod by pulling the cable release handle.
● Push the bottom of the tent pod all the way back until it is resting against the back of the storage box.
● Turn the crank handle counter-clockwise approx. 2 revolutions to lower the rack.
● TURN CRANK HANDLE CLOCKWISE approx. 1 full turn to re-engage the lift system clutch and take up any slack.
the system clicking when the clutch has re-engaged.
● Pull the 4 black nylon loops of the tent over the corner pins of the bed platforms.
● Attach plastic hooks/connectors to the GO frame to secure the tent.
step.
● Insert the 2 shorter side tent poles through the pole sleeves on both sides of the GO and insert the tips in the grommets.
● Insert the 1 longer vestibule pole through the sleeve over the door and insert the tips into the holes in the bed platform.

Setting Up the Interior

● Remove the 2 bed panels from the bungee on the back wall and place the ends in the sleeves on both sides of the GO to create a
solid surface on the bed platforms.
● Unzip the ceiling panel, pull down the 2 green sleeping pads, open both valves on each pad, and place on the bed platforms,
allowing them to self inflate. Close the valves after fully inflated.
● Unlatch the clasp on the table panels, push up to raise off the pin, flip the bar out of the way, and lower towards the back wall.
● Table setup: unlatch the top and remove 1 table panel, relatching the second panel. Bed setup: unlatch and remove both panels.
● Raise the 2nd panel back into the ceiling area, relatch, and zip the ceiling panel closed.
● Remove the black knob on the back wall.
● Attach one of the ratchet straps to the nylon loop on at the top of the back wall with the ratchet mechanism near this end.
● Place one end of the table panel where the knob sits and attach the other end to the hook of the ratchet strap.
● Secure the table panel to the wall with the black knob, only tightening one or two turns.
● Level table panel with ratchet

Packing Up

● Follow the steps in reverse order to pack up the GO.
Ver. 20230328-1
BAL leveler may be necessary terrain is very unlevel.
SylvanSport
See raising/lowering instructions on back.
Just enough to lock the back wall in place.
Ensure the loops are resting on the frame, not the pin.
There are 3 connection points on each corner of the frame & 2 at the
You will hear
sylvansport.com