illuburg ST-25M-DALI2 Datasheet And Operating Instructions
Led power supply with adjustable output current 25 w max., ip20, independent installation dimmable with dali2, push pri. flicker-free according to ieee 1789
Double-output led power supply with adjustable output current 50 w max., ip20, independent installation dimmable with 0-10v (1-10v, 10v pwm) dimmable with push (primary & secondary) flicker free according to ieee 1789 (10 pages)
Summary of Contents for illuburg ST-25M-DALI2
Page 1
Datasheet & Operating instructions ST-25M-DALI2 Page 1/10 Datasheet & Operating instructions Model: ST-25M-DALI2 LED power supply with adjustable output current 25 W max., IP20, independent installation dimmable with DALI2, PUSH (pri.) Flicker-free according to IEEE 1789 www.illuburg.de...
Datasheet & Operating instructions ST-25M-DALI2 Page 2/10 Safety Instructions • Be sure to switch off the mains voltage before assembly and disassembly. • Please keep this product away from children and pets. • Do not place this product under any mechanical stress.
Datasheet & Operating instructions ST-25M-DALI2 Page 3/10 Intended use The LED power supply is a power supply device specially designed for LED lighting. For safety and approval purposes (CE), you must not rebuild and/or modify this product. If you use this product for purposes other than those described above, the product may be damaged.
Datasheet & Operating instructions ST-25M-DALI2 Page 5/10 Electrical data Rated input voltage 220...240 Vac Range of input voltage 198...264 Vac Range of input voltage (DC) 200...240 Vdc Mains frequency 50/60 Hz Power factor (λ) ≥ 0.95 Full Load, 230 Vac No-load power consumption <...
Datasheet & Operating instructions ST-25M-DALI2 Page 6/10 Protection Short circuit protection Yes * Overvoltage protection Yes * Overheating protection Yes * Overload protection Yes * No-Load protection Yes * (*) The output shuts off and will be resumed, after problem is removed and led driver is restarted.
Page 8
Datasheet & Operating instructions ST-25M-DALI2 Page 8/10 Control via PUSH Button Action Duration Status Function LED on Turn off LED Short press once < 0.5 s LED off Turn on LED with latest brightness setting Dim the brightness up / down.
Page 9
Datasheet & Operating instructions ST-25M-DALI2 Page 9/10 Make sure there is a clearance of at least 15cm between the LED driver and other heat sources, e.g., other LED power supplies, lamps/LEDs etc. A distance of at least 5cm between the LED power supply and other non-heat-producing objects/surfaces is required.