HABCO SE18 Installation And Instruction Manual page 9

2. Standing in front of left hand sliding door, identify door roller re-
moval slot as this is where you will index the door roller (Fig H9).
DOOR REMOVAL SLOT(S)
3. Move right hand door to center position within cabinet door open-
ing (Fig H10).
4. Grasping right hand door firmly, one third from top, lift door up-
ward and out off top track, then swing the door bottom up and
away from bottom track.
5. Remove door from cabinet, down and away, resting against right
front wall.
6. Remove inner, left door, in the same manner except rather than
lifting up and out off track, lift door rollers up and swing bottom
of door into cabinet. Tilt door, lifting and resting against left front
wall.
FIG. H8
INCORRECT
FIG. H9
FIG. H10
© HABCO Manufacturing Inc. "HABCO®, Cassette®, Cold Space Merchandiser®" are registered trademarks of HABCO Manufacturing Inc. Domestic and International Patents. Page 9
Correct Door Closure Spring Orientation:
Right hand door closure spring must be installed on the right hook of
the left roller bracket (as shown Fig. H11). Conversely, the left hand
door closure spring must be installed on the left hook of the right roller
bracket.
Sliding Door Reinstallation:
1. Review door removal steps.
2. Grasping right hand door firmly, one third from top, lift door into
center position within cabinet opening.
3. Tilting the top of door inward, lift it upward onto upper track using
roller slots for adequate clearance. Still grasping the door firmly,
swing the bottom into the lower track.
4. Ensure that both rollers are seated into the door track at top, and
door bottom is contained within bottom track.
5. Inspect upper horizontal top door track "V" shaped sealer strip to
ensure that it is not binding, but freely resting atop inner and outer
door frame edges to create a seal (Fig 4).
6. Test both inner and outer doors to ensure they do not bind. If there
is resistance on opening or closure, then check:
a. rollers are seated into upper door track;
b. upper horizontal top door track "V" shaped sealer strip is
freely resting on inner and outer door frame edges (should
move left and right, up and down slightly when shaken);
c. door frame(s) is positioned within bottom "W" track.
Sliding Door Skew Adjustment:
HABCO® sliding doors have a skew adjustment feature.
Tools Required: Adjustable Wrench 3/16" Allen Key
1. Locate roller track cover at top of appliance above doors. Remove
screws located on both walls and ceiling behind roller track cover.
2. Remove doors, following instructions within this section.
3. Adjustable mounting brackets are pre-installed at the lowest set-
ting and tested for fluid motion prior to packaging. At the lowest
setting, the door hangs at the lowest point relative to the bottom
track of the cabinet (Fig H12).
HABCO® TECHNICAL DOCUMENT - C096832 • 10126169
FIG. H11