Quoizel Zephyr ZP8418MD Assembly Instruction Sheet

6 CORPORATE PARKWAY
, .
GOOSE CREEK SC 29445
. .
www quoizel com
Please go to www.quoizel.com
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Light Source: (1) T4 Mini Candelabra Bulb 50W Maximum (supplied).
Estimated Assembly Time:
Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Package Contents
T4 Mini Bulb
A
x 1
Hardware Contents
Crossbar
AA
x 1
-
STEP 1 Remove Glass Panel from Fixture Body
A. Locate the Fixture Body (B) onto a flat work surface. Loose Lock
Screws with Rubber Washers and then remove them and Glass
Panel from the Fixture Body (B).
Figure 1
Glass Panel
Lock Screw with Rubber Washer
Need assistance with parts or assembly? Call Quoizel customer service at 1-800-645-3184
2016 QuoizelInc.
Assembly Instruction Sheet #IS-ZP8418MD
for product cleaning tips. Go to the
30-45 minutes
Fixture Body
B
x 1
Lock Washer
BB
x 2
Hex Nut
CC
x 2
Mounting Screw
DD
x 2
Mounting Ball
EE
x 2
Alternate
FF Mounting screw
x 2
Thank you for purchasing a Quoizel product.
or visit us on-line at www.quoizel.com
For Style ZP8418MD
Care + Maintenance selection.
STEP 2 - Attach Mounting Screws, Lock Washers and Hex Nuts to
Crossbar
A. Line up a set of holes on the Crossbar (AA) and Holes on the
Backplate of Fixture Body (B). Thread Mounting Screws (DD) or
Alternate Short Mounting Screws (FF) into the holes on the
Crossbar (AA). Pass Lock Washers (BB) and thread Hex Nuts (CC)
onto the Mounting Screws (DD) or Alternate Short Mounting Screws
(FF). Hand tighten until snug.
Note: Use the Alternate Shorter Mounting Screw (FF) if your
installation requires a shorter mounting screw.
AA
Mounting Screw
or Alternate Short
Mounting Screw
STEP 3 - Installing the Crossbar Assembly
A. Pass the supply wires through the Crossbar (AA). Attach the
Crossbar (AA) to the Outlet Box with the head of the Green Ground
Screw facing you. Secure the Crossbar Assembly (AA) with Outlet
Box Screws (not included). Tighten until snug.
B
Figure 3
1of2
_R1
Backplate
AA
AA
BB
CC
Mounting Screw
or Alternate Short
Mounting Screw
Figure 2
Outlet Box
AA
Outlet Box Screws
(not included)
Supply Wires
with Ground Wire
RevisedDate:2016-11-10
B