Section 3-9 - Ac Power And Battery Installation Procedures - Wheelock SAFEPATH4 Application, Installation, Operation, And Maintenance Manual

Section 3-9 - AC Power and Battery Installation Procedures

NOTE: Power limited and non-power limited wiring must be separated.
WARNING: TWO DIFFERENT SOURCES OF POWER MAY BE CONNECTED TO THIS
UNIT. DISCONNECT BOTH SOURCES OF POWER BEFORE SERVICING. FAILURE TO
DISCONNECT BOTH POWER SOURCES BEFORE SERVICING COULD RESULT IN
PROPERTY DAMAGE, SERIOUS INJURY, OR DEATH TO YOU AND/OR OTHERS.
WARNING: OBSERVE CORRECT POLARITY REQUIREMENTS ON ALL CONNECTIONS.
FAILURE TO DO SO MAY DAMAGE THE EQUIPMENT.
WARNING: ALWAYS APPLY AC VOLTAGE BEFORE APPLYING BATTERY BACKUP
VOLTAGE. FAILURE TO DO SO MAY CAUSE DAMAGE TO THE SAFEPATH4 AUDIO
BOOSTER PANEL.
AC Power Installation Procedure
1. Using Figure 3-16 on Page 33, connect the line and neutral 120VAC input wiring to the L
(Line) and N (Neutral) terminals on the power supply module (SAPS).
2. Connect the ground input wiring to the grounding terminal block on the right side of the
chassis.
Battery Installation Procedure
NOTE: Batteries are not supplied with this panel and must be purchased separately.
1. Connect the supplied red battery wire to the (+) terminal and the supplied black battery wire
to the (–) terminal of TB4 (BATTERY) connection. (See Figure 3-17 on Page 34)
40