Table of Contents
Advertisement
Quick Links
92682-00 Fastdraw Pro Action Gap
WARNINGS
All installations must conform to local
plumbing codes and use approved backflow
prevention devices. A pressure indicating
tee is to be installed with existing faucets
according to local plumbing codes in the state
of Wisconsin and any other state that requires
the use of a pressure indicting tee.
ALWAYS WEAR PROTECTIVE CLOTHING AND
EYEWEAR WHEN WORKING WITH CHEMICAL
PRODUCTS.
92698-00 Fastdraw Pro Airgap
Technical Manual
Section
1. Parts Schematic/List ................................. 2 - 3
2. System Description .........................................4
3. Pre-Installation Requirements .........................4
4. Tools Required for Installation ........................4
5. System Installation .........................................5
6. Product Installation .........................................6
7. Drip Tray Installation .......................................6
8. Operation ........................................................6
9. Accessing Internal Dispenser Parts .................6
10. User Guidelines ...............................................6
11. Troubleshooting Guide ....................................7
Page
Advertisement
Table of Contents
Related Manuals for BETCO Fastdraw Pro 92682-00
Summary of Contents for BETCO Fastdraw Pro 92682-00
-
Page 1: Table Of Contents
92682-00 Fastdraw Pro Action Gap 92698-00 Fastdraw Pro Airgap Technical Manual Section Page WARNINGS 1. Parts Schematic/List ......... 2 - 3 2. System Description .........4 All installations must conform to local plumbing codes and use approved backflow 3. Pre-Installation Requirements ......4 prevention devices. -
Page 2: Parts Schematic/List
1. PARTS SCHEMATIC... - Page 3 PARTS LIST Number Description Qty. Part Number Water Valve Assembly 92699-00 Selector Push Button Assembly 92700-00 Bottle Fill Outlet Tube (Action Gap) 98318-00 Bottle Fill Outlet Tube (Air Gap) 98301-00 Bottle Fill Priming Tube (Air Gap) (Not shown) 98302-00 Bottle Fill Action Gap Eductor/Selector Assembly Complete 92701-00 Bottle Fill Air Gap Eductor/Selector Assembly Complete 92702-00...
-
Page 4: System Description
• Mounting options – The dispenser can be mounted in a corner or a flat wall. • Metering tips – No metering tips are needed. Each Betco refill comes with pre metered inserts. • Bottle or Bucket Fill – Each bay in this dispenser can fill bottles (1 GPM), mop buckets (4 GPM), or automatic scrubbers (4 GPM) •... -
Page 5: System Installation
5. SYSTEM INSTALLATION FLAT WALL INSTRUCTIONS CORNER MOUNT INSTRUCTIONS • Use cardboard mounting template • Unlock and open the dispenser for flat wall and mark 4 drill holes. door and hold the dispenser in the location to be mounted • Using the level, check to make sure the dispenser is level. -
Page 6: Product Installation
• Always reassemble equipment to instruction procedures. Be sure all components are firmly screwed or latched into position. • Use of any other product through FASTDRAW PRO system, other than products manufactured by Betco Corporation will void all warranties and may prevent the system from operating properly. -
Page 7: Troubleshooting Guide
10. TROUBLESHOOTING CHART Problem Cause Solution 1. Unit does not dispense Water supply is shut off. Turn on water supply. Water valve is not functioning. Replace valve components as shown in parts schematic. Excessive or low pressure. Install a pressure regulator a 40 psi pressure regulator if pressure exceeds recommendation. - Page 8 ©2023 Betco Corporation All Rights Reserved. 400 Van Camp Road Bowling Green, Ohio 43402 03/2023...
Need help?
Do you have a question about the Fastdraw Pro 92682-00 and is the answer not in the manual?
Questions and answers