Roland MC-505 Install Manual page 5

Roland MC-505 LCD Replacement Guide
Fig. 5 - Back of the Case
Step 2:
Remove 6 screws from the back of the case.
These are circled in the Fig. 5 photo above.
You will also need to remove the plastic nuts from the 1/4"
sockets on the back of the case. You may need to loosen the nuts
using a wrench. A 14mm or 9/16" wrench or an adjustable wrench
can be used to loosen these nuts if needed.
Once again be sure to make note of which screws go where and
store them so they're not lost. Since there are multiple different
types / sizes of screws, it is a good idea not to mix them up.
Personally, I used separate zip lock bags for each section of the
process in this guide.
4
produced by: glitchscience.com
2020©