Table of Contents
Advertisement
Dealing with Problems (Summary)
Fast User Switching Function
Some applications may not work
properly
Wireless LAN
Wireless LAN cannot be used
Access point is not detected
Expanding Memory
You do not know the available RAM
module
Cannot tell whether the RAM module
has been correctly installed
The RAM module has not been rec-
ognized
Other Problems
No response
Cannot operate Fn keys (
22)
46
When switching to a different user with the Fast User Switching function,
the following problems may occur:
• Some applications may not work properly
• Key combination with the Fn key may not work
• It may not be possible to set the settings of the display
• The wireless LAN cannot be used
• The B's CLiP icon will no longer be shown on the notification area and B's
CLiP cannot be used
In this case, log-off all users without using Fast User Switching function,
and try the operation once more. If the problem persists, restart the com-
puter.
When the wireless LAN function is turned off, turn it on using Intel(R)
PROSet.
(
page 34)
Even if the wireless LAN function is turned on, when access point is not dis-
played in [Available Networks] from [Intel(R) PROSet] - [Networks] - [Scan],
click [Refresh].
For detailed information, refer to "Networking: Wireelss LAN" of "Chapter 7:
Dealing with Problems (Advanced)" in onscreen Reference Manual
page 57
You can check whether the RAM module is recognized using the [Informa-
tion] menu in the Setup Utility. (
If the RAM module is not recognized, turn the computer off and reinsert.
Make sure the RAM module has been properly inserted
Use the RAM module that supports the recommended specifications
(
page 23)
Press the Ctrl+Shift+Esc key to open Task Manager and close the soft-
ware application that is not responding
Is there an input screen (e.g., password input screen at startup) hidden
behind another window? Use the Alt+Tab key to check for other windows
being displayed
After shutting down by sliding the power switch for more than four seconds,
slide the power switch to power on and open the application again. If the
program no longer works normally, delete the program using the following
menu. Then reinstall the program
[start] - [Control Panel] - [Add or Remove Programs]
page
In the [Main] menu of the Setup Utility, is [Fn/Ctrl Key] set to [Replace]?
(
page 27)
Return the setting to [Normal], or press the Ctrl key instead of the Fn key
if you want to leave the setting in [Replace]
page 26)
Advertisement
Table of Contents
