Table of Contents
Advertisement
Enter Password [
NOTE
The power saving function is factory set, so if there is no input from a key, the touch
pad or an external mouse (when one is connected) for a certain interval of time, the
power to the LCD and hard disk may be turned off. The LCD will resume operation
when the touch pad or an external mouse (when one is connected) is used or a key is
pressed.
The power to the LCD may be turned off even when an application software is being
installed. In this case, because it is conceivable that a selection dialog box will be
shown, do not press Space or Enter to attempt to resume from this condition
as doing so may trigger a selection, but instead, press a key unrelated to the direct
triggering of a selection, like Ctrl .
In addition, when the computer is left alone, it automatically enters the standby or
hibernation mode (
resume by sliding the power switch.
If the screen on the left is displayed immediately after you turn
]
on the power...
A password has been set to ensure the computer's security.
Enter your password*
When the correct password is input, the computer will start.
When three incorrect password attempts or nothing is input for one minute, the com-
puter will power off.
1
*
Supervisor Password or User Password set in the Setup Utility (not the Windows password).
"Standby/Hibernation Functions"). The computer will
1
and press Enter . (
"Security Measures")
17
Advertisement
Table of Contents
