Advertisement
1. Plug the blue connector into the 12V Jump Starter port (A); LED (B) illuminates red.
2. Connect the red damp to positive '+' on the vehicle's battery. Connect the black clamp to negati-
ve '-' on the vehicles battery. lf connected correctly LED (B) illuminates green. lf LED flashes red it's
more than likely the clamps have been incorrectly connected, remove clamps & connect correctly,
the LED should now be green. Even if with the clamps connected correctly the LED flashes red,
remove the red clamp & re-connect to reset.
3. If Green, proceed to start vehicle.
4. Once the vehicle has started and the LED flashes green, disconnect the clamps from the vehicle's
battery and then remove the jumper cables from the jump starter.
Recharging the Jump starter
To charge the jump starter, connect (A) with (E) then plug into any USB charging port (not included)
or with 12V charger (C). The four Indicator lights will flash. When the four Indicator lights are solid
illuminated, the jump starter battery is completely charged.
3. TROUBLESHOOTING
Problem
Jump starter does not
jump start vehicle.
Red blinking
Jump starter does not
jump start vehicle.
Green blinking
Possible Cause
1. Battery may not
1. Charge the jump starter
have sufficient
charge.
2. Reconnect the clamps
2. Jumper cable clamps
maybe improperly
connected to the
vehicle's battery.
3. Over temperature
3. Make sure the Jump
1. Not properly
connected
2. Jump starter/charger
voltage level lower
than vehicle battery
voltage
Solution
to sufficient charge.
to the proper battery
terminals, and ensure
the jumper cable's LED
is illuminated green
starter cooled to
usage temperature
1. Reconnect the
clamps to the vehicle
battery
2. Vehicle battery has
enough charge to
start car
3
Advertisement
